Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (d) 4 m — The sloping slide is the hypotenuse of a right-angled triangle with the other two sides 2.4 m and 3.2 m. By Pythagoras' Theorem, hypotenuse² = 2.4² + 3.2² = 5.76 + 10.24 = 16. Square root: √16 = 4 m. Adding the two sides instead of squaring them gives 2.4 + 3.2 = 5.6 m. Truncating each squared side to a whole number before adding (5.76 to 5 and 10.24 to 10) gives √15 ≈ 3.87 m. Forgetting to take the square root and leaving the sum of the squares as the answer gives 5.76 + 10.24 = 16, written as 16 m.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) 13 — Method: OP and PQ meet at a right angle because of the tangent–radius fact, so triangle OPQ is right-angled at P; use Pythagoras' theorem. Working: OQ² = OP² + PQ² = 5² + 12² = 25 + 144 = 169; OQ = √169 = 13. A student who answers 17 has simply added the two given lengths (5 + 12) instead of using Pythagoras' theorem. A student who answers 7 has subtracted the two given lengths (12 − 5) instead of using Pythagoras' theorem. A student who answers 144 has correctly squared 12 but stopped there, forgetting to add 5² and take the square root. Answer: 13 cm.
- (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
- (a) Two sides equal, with the angle between them equal — Method: recall what each letter in SAS stands for, and the order they must appear in. Working: SAS stands for Side, Angle, Side — two pairs of equal sides, with the equal angle positioned between them. Options: 'two sides and any one angle' describes SSA, which is not valid, since the angle must specifically be the included one; 'two angles with the side between them' describes ASA, a different condition; 'all three pairs of sides' describes SSS, also different. Answer: two sides equal, with the angle between them equal.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (b) 22 — Method: add the two drawn lengths together first, then apply the scale to the total. Working: 3 cm + 2.5 cm = 5.5 cm; 5.5 cm × 4 = 22 m. A student who answers 10 has only converted one of the two sections (2.5 cm × 4) and forgotten the other. A student who answers 5.5 has added the two drawn lengths but forgotten to apply the scale at all. A student who answers 44 has doubled the correct answer, effectively applying the scale twice. Answer: 22 m.
- (c) Radius — Method: recall that a sector is formed using two straight lines drawn from the centre out to the circle's edge. Working: each straight edge of a sector runs from the centre of the circle to a point on the circumference. A student who answers chord has confused a straight edge from the centre with one joining two points on the circumference. A student who answers diameter has wrongly assumed the two straight edges must form a single full diameter. A student who answers arc has named the curved edge instead of the straight edges. Answer: radius (radii).
- (b) 360 cm² — Method: the total surface area is the square base plus the four triangular faces, and the height used for a triangular face is the slant height of 13 cm, not the vertical height of 12 cm. Working: the base is 10 × 10 = 100 cm²; one triangular face is (10 × 13) ÷ 2 = 65 cm², so four faces give 4 × 65 = 260 cm²; the total is 100 + 260 = 360. Answer: 360 cm². The distractors: 260 cm² comes from adding the four triangular faces and leaving out the base; 340 cm² comes from using the vertical height of 12 cm as the height of each triangle, 100 + 4 × 60; 620 cm² comes from working out each face as 10 × 13 without halving, 100 + 4 × 130.
Build your own mix at the worksheet builder.