Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 125° — Method: two angles that sit next to each other at a crossing point lie on a straight line, so they add up to 180°; the angle that faces the given one across the point is the equal one, and that is not the angle asked for here. Working: 180° − 55° = 125°. Answer: 125°. The distractors: 55° is the angle vertically opposite the given one, taken by a candidate who reads “next to” as the facing angle and applies the equal-angles rule to the wrong pair; 35° comes from subtracting from 90°, treating the pair as complementary instead of as angles on a straight line; 90° comes from assuming that a line crossing a pair of parallel lines must meet them at right angles, which the question never says.
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (d) 4 — Method: use the definition of a rectangle — a quadrilateral in which every interior angle is a right angle. Working: a quadrilateral has four interior angles, and in a rectangle all four of them measure 90°, which is consistent with the 360° angle sum because 4 × 90° = 360°. Answer: 4. The distractors: 2 comes from applying the rule that opposite angles are equal and concluding that only one pair of corners is square; 1 comes from thinking that a single square corner is enough to make a shape a rectangle; 0 comes from confusing a rectangle with a general parallelogram, which has no right angles unless it is a rectangle.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (a) 110° — The angles in a quadrilateral add up to 360°. So 40° + 100° + W + W = 360°, giving 2W = 360° − 140° = 220°, so W = 110°. A pupil who works out 2W = 220° but forgets to divide by 2, since there are two equal angles W, gives 220°. A pupil who mistakenly uses the angle sum of a triangle, 180°, instead of 360°, gets 180° − 140° = 40°. A pupil who simply adds the two given angles together instead of subtracting from 360° gets 40° + 100° = 140°. The correct answer is 110°.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (b) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs of parallel sides, not one, so it does not fit the definition. A kite has no parallel sides at all. A rhombus, like a parallelogram, has two pairs of parallel sides. The correct name is trapezium.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (c) 10 cm — The diagonals of a rhombus bisect each other at right angles, splitting it into four congruent right-angled triangles with legs 8 cm (half of 16 cm) and 6 cm (half of 12 cm). By Pythagoras' Theorem, side² = 8² + 6² = 64 + 36 = 100. Square root: √100 = 10 cm.
- (b) 22 — Method: add the two drawn lengths together first, then apply the scale to the total. Working: 3 cm + 2.5 cm = 5.5 cm; 5.5 cm × 4 = 22 m. A student who answers 10 has only converted one of the two sections (2.5 cm × 4) and forgotten the other. A student who answers 5.5 has added the two drawn lengths but forgotten to apply the scale at all. A student who answers 44 has doubled the correct answer, effectively applying the scale twice. Answer: 22 m.
- (b) 3 — Method: the scale factor is a length of the second triangle divided by the corresponding length of the first, and corresponding means shortest paired with shortest. Working: the shortest side of the first triangle is 3 cm and the shortest side of the second is 9 cm, so the scale factor is 9 ÷ 3 = 3. Answer: 3. The distractors: 1/3 comes from dividing 3 by 9, which is the scale factor from the second triangle back to the first; 6 comes from subtracting, 9 − 3, treating the scale factor as a difference rather than a multiplier; 1.8 comes from dividing 9 by 5, pairing the second triangle's shortest side with the first triangle's longest side.
- (d) RHS, using AM as common side — Triangle ABM and triangle ACM both have a right angle at M, since AM is perpendicular to BC. AB and AC are the hypotenuses of the two triangles and are equal, and AM is a side common to both triangles, giving a right angle, equal hypotenuses and one further equal side, exactly RHS, so 'RHS, using AM as common side' is correct. 'SAS, right angle as included angle' wrongly treats the right angle at M as included between AB and AM, but AB is the hypotenuse, not one of the two sides forming that right angle. 'SSS, using BM = CM as a fact' wrongly assumes BM equals CM as a given fact, when this is only true because of the RHS congruence, not before it, so it cannot be used to prove that congruence. 'ASA, AB as the included side' again wrongly labels a side as if it could sit between two angles when only one angle, the right angle, is actually known.
Build your own mix at the worksheet builder.