Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 1/2 — Method: cos 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2, base 1 and height √3. Working: cosine is the adjacent side over the hypotenuse, the side alongside the 60° angle is the base of length 1, and the hypotenuse is 2, so cos 60° = 1 ÷ 2. Answer: cos 60° = 1/2. A candidate who assumes the cosine falls steadily from cos 0° = 1 to cos 90° = 0 puts 60° two thirds of the way along and writes 1/3; the cosine does not change at a constant rate. Reading the start of the cosine row gives cos 0° = 1, and reading its end gives cos 90° = 0.
- (a) 750 — Method: to change kilograms to grams, multiply by 1000. Working: 0.75 × 1000 = 750. Answer: 750 g. A candidate who multiplies by 100 instead of 1000 gets 75. A candidate who multiplies by 10000 instead of 1000 gets 7500. A candidate who divides by 1000 instead of multiplying gets 0.00075.
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (b) (2, 6) — To add column vectors, add the top numbers together and add the bottom numbers together, separately: top = 3 + (−1) = 2, bottom = 2 + 4 = 6, giving (2, 6). A candidate who writes the top and bottom numbers of the correct answer in the wrong order gives (6, 2). A candidate who subtracts instead of adds, working out 3 − (−1) = 4 and 2 − 4 = −2, gives (4, −2). A candidate who adds the top numbers correctly but subtracts the bottom numbers by mistake, working out 2 − 4 = −2, gives (2, −2). The correct answer is (2, 6).
- (b) Square — A square has all four sides equal, all four angles equal to 90°, and diagonals that are equal in length and bisect each other at right angles — every part of the description matches, so Square is correct. A rhombus has all four sides equal and diagonals bisecting at right angles, but its interior angles are not generally 90° (only a square, a special rhombus, has that), so it does not fully match. A rectangle has four 90° angles and equal diagonals, but its sides are not all equal in general, so it fails the equal-sides condition. A kite has two pairs of adjacent equal sides rather than all four sides equal, and its diagonals are not generally equal in length, so it fails both conditions.
- (b) Draw wider arcs from each crossing point, meeting above. — Once the two arcs cross the line at points either side of P, compasses are opened to a radius greater than before and arcs are drawn from each of those two points so that they meet above (or below) the line; joining that meeting point to P gives the perpendicular. (Joining the two crossing points with a straight line only retraces part of the original line, since both points already lie on it; drawing a circle centred at P through both crossing points does not locate any new point needed for the perpendicular; drawing an arc centred at P through only one crossing point repeats the first step instead of moving on to the second pair of arcs.)
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (d) 125° — Method: two angles that sit next to each other at a crossing point lie on a straight line, so they add up to 180°; the angle that faces the given one across the point is the equal one, and that is not the angle asked for here. Working: 180° − 55° = 125°. Answer: 125°. The distractors: 55° is the angle vertically opposite the given one, taken by a candidate who reads “next to” as the facing angle and applies the equal-angles rule to the wrong pair; 35° comes from subtracting from 90°, treating the pair as complementary instead of as angles on a straight line; 90° comes from assuming that a line crossing a pair of parallel lines must meet them at right angles, which the question never says.
- (a) 60° — Method: the three angles of a triangle add up to 180°, so add the two known angles and subtract the total from 180°. Working: 50 + 70 = 120, then 180 − 120 = 60. Answer: 60°. The distractors: 120° is the sum of the two known angles, given as the answer instead of being subtracted from 180°; 110° comes from subtracting only the 70° angle from 180° and forgetting the 50° one; 240° comes from subtracting the sum from 360°, using the angles at a point rather than the angle sum of a triangle.
- (c) 6 — A cuboid has six flat faces: a top, a bottom and four sides. Count each flat surface once: top, bottom, front, back, left, right — six faces in total, so the answer is 6. Choosing 8 counts the vertices (corners) instead of the faces. Choosing 12 counts the edges instead of the faces. Choosing 4 counts only the four side faces and forgets the top and the bottom.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (b) Triangle — Method: the front elevation is the outline you see looking straight at the solid's front face. Working: this solid's front face is one of its two identical triangular ends, so looking directly at the front shows exactly that triangular outline. Answer: triangle. The distractors: rectangle comes from picturing the side view instead of the front view — looking along the ridge of the prism, the sloping roof faces project as a rectangle. Trapezium comes from misreading the two sloping roof faces as if together they formed a single four-sided shape. Pentagon comes from tracing round the outline of the whole sketch as it is drawn on the page, which is a five-sided shape, instead of drawing only the view seen looking straight at the front of the solid.
- (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
- (c) 3π cm — Circumference = πd. With d = 3 cm, circumference = π × 3 = 3π cm. A student who uses the radius (1.5 cm) instead of the diameter in the formula gets 1.5π cm.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
Build your own mix at the worksheet builder.