Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (a) 7 — Rearranging F + V − E = 2 gives F = 2 − V + E = 2 − 10 + 15 = 7. A candidate who works out E − V without the +2, giving 15 − 10, answers 5. A candidate who rearranges with a sign error, working out 2 + V − E = 2 + 10 − 15 = −3 and then drops the negative sign, answers 3. A candidate who adds all three numbers together, V + E + 2 = 10 + 15 + 2, answers 27, having used the wrong operation entirely. The correct number of faces is 7.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
- (d) 15 cm² — Method: identify the length that is common to both views, since it is the box's length; then read off the width from the plan view and the height from the front elevation, and multiply those two measurements to find the area of the side elevation. Working: both rectangles share a side of 8 cm, which is the box's length; the plan view's other side gives a width of 5 cm, and the front elevation's other side gives a height of 3 cm. The side elevation is bounded by the width and the height: 5 cm × 3 cm = 15 cm². Answer: 15 cm². The distractors: 24 cm² comes from giving the area of the front elevation shown (8 cm × 3 cm) instead of working out a new rectangle for the side elevation. 40 cm² comes from giving the area of the plan view shown (8 cm × 5 cm) instead of working out the side elevation. 120 cm² comes from multiplying all three measurements together (8 cm × 5 cm × 3 cm), finding the volume of the box instead of the area of one face.
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (c) 1 — Method: a right angle measures 90°, the three angles of any triangle add up to 180°, and a right-angled triangle is defined as a triangle that contains a right angle. Working: taking one right angle out of the total leaves 180° − 90° = 90° to be shared between the other two angles, so both of those must be acute; a second right angle would use the whole of that remaining 90° and leave nothing at all for the third angle, which is impossible. The definition therefore fixes the count at exactly one. Answer: 1. The distractors: 2 comes from counting the two sides that form the right angle instead of counting the angles themselves; 3 comes from reading the name as a description of the whole triangle, so that all three of its angles are taken to be right angles, which would need an angle sum of 3 × 90° = 270°; 0 comes from over-applying the angle sum — a candidate who works out that 90° + 90° = 180° leaves nothing for a third angle can conclude from that alone that no triangle may contain a right angle at all.
Build your own mix at the worksheet builder.