Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (d) 4 — Method: use the definition of a rectangle — a quadrilateral in which every interior angle is a right angle. Working: a quadrilateral has four interior angles, and in a rectangle all four of them measure 90°, which is consistent with the 360° angle sum because 4 × 90° = 360°. Answer: 4. The distractors: 2 comes from applying the rule that opposite angles are equal and concluding that only one pair of corners is square; 1 comes from thinking that a single square corner is enough to make a shape a rectangle; 0 comes from confusing a rectangle with a general parallelogram, which has no right angles unless it is a rectangle.
- (c) 67° — Angles on a straight line add up to 180°. Add the two known angles: 48° + 65° = 113°. Subtract from 180°: 180° − 113° = 67°.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (a) Every square is a rectangle — Method: test each statement against the definitions. A rectangle is a quadrilateral with four right angles and opposite sides equal; a square is a quadrilateral with four right angles and all four sides equal; a rhombus is a quadrilateral with all four sides equal. Working: a square has four right angles and its opposite sides are equal, so every square meets the definition of a rectangle and the statement that every square is a rectangle is true. Answer: every square is a rectangle. The distractors: the claim that every rectangle is a square reverses the inclusion, and fails for any rectangle whose length and width differ; the claim that every rhombus is a rectangle treats four equal sides as enough, and drops the right-angle condition — a tilted rhombus has no right angles; the claim that every rectangle is a rhombus reads 'opposite sides equal' as though it meant 'all four sides equal'.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) 68 cm² — Method: the area of a parallelogram is base × perpendicular height. Working: 4 × 17 = 68. Answer: 68 cm². The distractors: 34 cm² comes from halving the product, which is the rule for a triangle and not for a parallelogram; 42 cm comes from treating the two given lengths as the sides of the shape and working out a perimeter, 2 × (4 + 17), which is a length and not an area; 21 cm comes from adding the base and the height, 4 + 17, instead of multiplying them.
- (a) 3 squares — Method: the plan view shows only the floor positions that have at least one cube standing on them; height does not add extra squares to the plan. Working: the base row occupies three floor positions in a line. The two extra cubes stand on top of two of those same three positions, so they do not create any new floor position. Answer: 3 squares. The distractors: 5 squares comes from adding the total number of cubes used (3 + 2 = 5) instead of counting distinct floor positions. 2 squares comes from counting only the raised two-cube section and ignoring the single cube at the other end of the row. 4 squares comes from counting one of the shared positions twice.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (c) RHS applies: the right angle, hypotenuse and one matching side are all equal — Both triangles are right-angled, and the hypotenuses (AC and DF) are equal, and one further pair of matching sides (AB and DE) are equal. This matches the Right angle-Hypotenuse-Side condition, which needs only these three facts, not a third side.
Build your own mix at the worksheet builder.