Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (b) 045° — North is 000° and east is 090°; halfway between them, measured clockwise, is 045°. Choosing 090° gives east itself, not the midpoint between north and east. Choosing 135° gives the midpoint between east (090°) and south (180°) instead of between north and east. Choosing 225° is the back bearing of 045° (045° + 180°), not the bearing itself.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (c) 6 squares — Method: the plan view shows the footprint of the solid; a second layer stacked on top of floor positions that are already covered does not create any new squares in the plan. Working: the row of 4 cubes and the row of 2 cubes attached at the end do not overlap, so the footprint has 4 + 2 = 6 distinct squares. Answer: 6 squares. The distractors: 12 squares comes from counting the total number of cubes used, including the second layer (6 floor positions × 2 layers = 12), instead of the footprint. 4 squares comes from counting only the row of four and forgetting the attached row of two. 5 squares comes from wrongly treating the corner square as shared between the two rows (4 + 1 instead of 4 + 2).
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (b) (3, −2) — A 90° clockwise rotation about the origin maps (x, y) to (y, −x): (2, 3) → (3, −2). A pupil who uses the rule for a 90° anticlockwise rotation instead, (x, y) → (−y, x), gets (−3, 2). A pupil who uses the rule for a 180° rotation, (x, y) → (−x, −y), gets (−2, −3). A pupil who swaps the coordinates but forgets to change any sign gets (3, 2). The correct image is (3, −2).
- (d) The centre — Method: sort the four names by what kind of object each one is, because only one of them names a single point rather than a line or a curve. Working: a chord is a straight line joining two points on the circle; a diameter is the special chord that runs right across the circle through the middle, so it too is a line; an arc is a piece of the circle's own curve. That leaves one name, and it belongs to the point from which every radius is drawn, which is why every point on the circle is the same distance from it. Answer: The centre. The distractors: The chord is picked by a candidate who reads 'the same distance' as a line of fixed length rather than as a point; The diameter is picked by a candidate who names the line that passes through the point instead of the point itself; The arc is picked by a candidate who hunts for a part of the circle's own curve rather than for a point inside it.
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (a) (3, 9) — Two column vectors are parallel only when one is the other multiplied by a single scalar — both numbers scaled by the same factor with the same sign. r has top:bottom ratio 2:6, which simplifies to 1:3. (3, 9) has ratio 3:9, also 1:3, so (3, 9) = 1.5 × r: it is parallel to r. (6, 2) swaps the top and bottom numbers of r, giving ratio 6:2 (3:1), which is not the same ratio. (2, 3) halves only the bottom number of r, giving ratio 2:3, not 1:3. (−2, 6) changes the sign of only the top number of r, giving ratio −2:6, which no longer matches 2:6 throughout.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
Build your own mix at the worksheet builder.