Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) ASA - two angles and the included side equal — Two angles (A and B) are given, and AB is the side between them, so this is ASA. SAS needs two sides and the angle between them, but only one side is given. AAS also uses two angles and a side, but the side must NOT be between the two angles — here AB is between angle A and angle B, so it is ASA, not AAS. RHS needs a right angle, and neither 40° nor 65° is 90°.
- (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
- (a) 6 — A cuboid has six faces in total: a top, a bottom, a front, a back, and two ends — each one is a rectangle in the net, giving six rectangles altogether. Choosing 3 counts only the three PAIRS of congruent rectangles (top/bottom, front/back, two ends) rather than all six individual faces. Choosing 5 forgets one face, as if the net were missing its lid. Choosing 12 is the number of edges of a cuboid, not the number of rectangles in its net.
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (c) (−2, 10) — To translate M(3, 8) by $\binom{−5}{2}$, add −5 to the x-coordinate and 2 to the y-coordinate: (3 + (−5), 8 + 2) = (−2, 10). (5, 3) comes from swapping the two components of the vector before applying them. (−2, 8) applies only the x-component and forgets to add the y-component. (3, 10) applies only the y-component and forgets to add the x-component.
- (d) SSS - three sides equal — All three pairs of corresponding sides are equal in length (5 cm, 7 cm and 9 cm in both triangles), so the triangles are congruent by SSS. SAS needs an angle to be given as well as two sides, but no angle is given here. ASA needs two angles and the side between them, but no angles are given at all. RHS needs a right angle and the hypotenuse, but no angle is stated to be a right angle.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
- (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (d) 1.5 m — By Pythagoras' theorem, diagonal² = 1.2² + 0.9² = 1.44 + 0.81 = 2.25, so diagonal = √2.25 = 1.5 m. 2.1 m comes from simply adding the two sides (1.2 + 0.9) instead of using Pythagoras' theorem. 0.3 m comes from subtracting the two sides (1.2 − 0.9) instead. 2.25 m comes from correctly finding 1.2² + 0.9² = 2.25 but forgetting to take the square root at the end.
- (c) −1.5 — Since n = k × m, dividing a number in n by the matching number in m gives k: k = −6 ÷ 4 = −1.5 (check with the bottom numbers: −9 ÷ 6 = −1.5, the same value, confirming n is a scalar multiple of m). 1.5 has the correct size but is missing the negative sign. −10 comes from subtracting the top numbers, −6 − 4, instead of dividing them. −24 comes from multiplying the top numbers, −6 × 4, instead of dividing them.
Build your own mix at the worksheet builder.