Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (d) 5 — Method: since the triangles are congruent by SAS, the corresponding sides AB and DE must be equal, because both are the side next to the given right angle that is not BC or EF. Working: AB = DE gives 2x + 3 = 13, so 2x = 10, so x = 5. Options: 10 comes from dropping the coefficient of x and solving x + 3 = 13 instead of 2x + 3 = 13; 4 comes from matching AB to the wrong side, EF, giving 2x + 3 = 11, so 2x = 8, so x = 4; 8 comes from a sign error, solving 2x − 3 = 13 instead of 2x + 3 = 13, giving 2x = 16, so x = 8. Answer: 5.
- (a) Every square is a rectangle — Method: test each statement against the definitions. A rectangle is a quadrilateral with four right angles and opposite sides equal; a square is a quadrilateral with four right angles and all four sides equal; a rhombus is a quadrilateral with all four sides equal. Working: a square has four right angles and its opposite sides are equal, so every square meets the definition of a rectangle and the statement that every square is a rectangle is true. Answer: every square is a rectangle. The distractors: the claim that every rectangle is a square reverses the inclusion, and fails for any rectangle whose length and width differ; the claim that every rhombus is a rectangle treats four equal sides as enough, and drops the right-angle condition — a tilted rhombus has no right angles; the claim that every rectangle is a rhombus reads 'opposite sides equal' as though it meant 'all four sides equal'.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (a) (2, 6) — To translate by the vector (−3, 4), add −3 to the x-coordinate and add 4 to the y-coordinate: (5 − 3, 2 + 4) = (2, 6). A pupil who adds 3 instead of subtracting for the x-coordinate gets (8, 6). A pupil who swaps the x- and y-components of the vector gets (5 + 4, 2 − 3) = (9, −1). A pupil who subtracts both components instead of adding the y-component gets (5 − 3, 2 − 4) = (2, −2). The correct image is (2, 6).
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (d) The centre — Method: sort the four names by what kind of object each one is, because only one of them names a single point rather than a line or a curve. Working: a chord is a straight line joining two points on the circle; a diameter is the special chord that runs right across the circle through the middle, so it too is a line; an arc is a piece of the circle's own curve. That leaves one name, and it belongs to the point from which every radius is drawn, which is why every point on the circle is the same distance from it. Answer: The centre. The distractors: The chord is picked by a candidate who reads 'the same distance' as a line of fixed length rather than as a point; The diameter is picked by a candidate who names the line that passes through the point instead of the point itself; The arc is picked by a candidate who hunts for a part of the circle's own curve rather than for a point inside it.
- (a) Two sides equal, with the angle between them equal — Method: recall what each letter in SAS stands for, and the order they must appear in. Working: SAS stands for Side, Angle, Side — two pairs of equal sides, with the equal angle positioned between them. Options: 'two sides and any one angle' describes SSA, which is not valid, since the angle must specifically be the included one; 'two angles with the side between them' describes ASA, a different condition; 'all three pairs of sides' describes SSS, also different. Answer: two sides equal, with the angle between them equal.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (d) SAS — Method: a congruence condition is named by the parts that are given equal and the order in which they sit round the triangle, so count the sides and the angles first. Working: AB = DE and AC = DF are two pairs of equal sides, and the equal angle at A and D lies between AB and AC, so the given parts read side, included angle, side. Answer: SAS. The distractors: SSS needs three pairs of equal sides, and the third pair, BC and EF, is not given — it follows from the proof rather than being part of it; ASA reads the two equal sides as two equal angles, swapping which facts are which; RHS applies only when the triangles contain a right angle and the equal pair includes the hypotenuse, and nothing here says the angle at A is 90°.
- (d) 1250 g — There are 1000 g in a kilogram, so 1.25 kg = 1.25 × 1000 = 1250 g. Multiplying by 100 instead of 1000 gives 125 g. Converting only the whole 1 kg and forgetting the extra 0.25 kg gives 1000 g. Treating the 0.25 kg as 25 g instead of 250 g, a quarter of 1000, gives 1025 g.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
Build your own mix at the worksheet builder.