Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) (3, 9) — Two column vectors are parallel only when one is the other multiplied by a single scalar — both numbers scaled by the same factor with the same sign. r has top:bottom ratio 2:6, which simplifies to 1:3. (3, 9) has ratio 3:9, also 1:3, so (3, 9) = 1.5 × r: it is parallel to r. (6, 2) swaps the top and bottom numbers of r, giving ratio 6:2 (3:1), which is not the same ratio. (2, 3) halves only the bottom number of r, giving ratio 2:3, not 1:3. (−2, 6) changes the sign of only the top number of r, giving ratio −2:6, which no longer matches 2:6 throughout.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
- (d) √3 — tan 60° = √3 — one of the exact values you need to know without a calculator. √3/2 is the exact value of sin 60° and of cos 30°, not tan 60°. 1/√3 is the exact value of tan 30°, the reciprocal-angle case. 3 comes from squaring √3 instead of reading off tan 60° itself.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (b) (5, −2) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate, so (5, 2) → (5, −2). ((−5, 2) comes from reflecting in the y-axis instead, changing the sign of the x-coordinate; (−5, −2) comes from changing the sign of both coordinates, as for a reflection in the origin; (2, 5) comes from swapping the coordinates, which is what happens for a reflection in the line y = x.)
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (a) Every square is a rectangle — Method: test each statement against the definitions. A rectangle is a quadrilateral with four right angles and opposite sides equal; a square is a quadrilateral with four right angles and all four sides equal; a rhombus is a quadrilateral with all four sides equal. Working: a square has four right angles and its opposite sides are equal, so every square meets the definition of a rectangle and the statement that every square is a rectangle is true. Answer: every square is a rectangle. The distractors: the claim that every rectangle is a square reverses the inclusion, and fails for any rectangle whose length and width differ; the claim that every rhombus is a rectangle treats four equal sides as enough, and drops the right-angle condition — a tilted rhombus has no right angles; the claim that every rectangle is a rhombus reads 'opposite sides equal' as though it meant 'all four sides equal'.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (b) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs of parallel sides, not one, so it does not fit the definition. A kite has no parallel sides at all. A rhombus, like a parallelogram, has two pairs of parallel sides. The correct name is trapezium.
- (d) a rectangle — The shed is a prism, so its two triangular ends are identical and parallel, a fixed distance apart along the shed's length; the floor they stand on is therefore bounded by the base of one triangle, the base of the other, and the two straight edges joining them — a rectangle. Looking straight down, the sloping roof projects onto that same rectangle rather than outside it, so the plan view is a plain rectangle, as long as the shed and as wide as its gable end. "a triangle" is the shape of the END wall, seen from the front or back, not from above. "a triangle with a rectangle attached" wrongly combines a side-elevation feature with the plan — the plan does not show the triangular end wall at all, since looking down hides it completely. "two triangles joined at their bases" describes neither the plan nor any single elevation of this shed.
Build your own mix at the worksheet builder.