Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (c) 1 — Method: a right angle measures 90°, the three angles of any triangle add up to 180°, and a right-angled triangle is defined as a triangle that contains a right angle. Working: taking one right angle out of the total leaves 180° − 90° = 90° to be shared between the other two angles, so both of those must be acute; a second right angle would use the whole of that remaining 90° and leave nothing at all for the third angle, which is impossible. The definition therefore fixes the count at exactly one. Answer: 1. The distractors: 2 comes from counting the two sides that form the right angle instead of counting the angles themselves; 3 comes from reading the name as a description of the whole triangle, so that all three of its angles are taken to be right angles, which would need an angle sum of 3 × 90° = 270°; 0 comes from over-applying the angle sum — a candidate who works out that 90° + 90° = 180° leaves nothing for a third angle can conclude from that alone that no triangle may contain a right angle at all.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (b) 50 cm² — Method: the area of a rectangle is length × width. Working: 2 × 25 = 50. Answer: 50 cm². The distractors: 54 cm comes from working out the perimeter, 2 × (2 + 25), which is a length and not an area; 27 cm comes from adding the two sides, 2 + 25, instead of multiplying them; 25 cm² comes from halving the product, 50 ÷ 2, which is the rule for the area of a triangle rather than of a rectangle.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) Nonagon — Method: match the number of sides given to the correct polygon name. Working: a polygon with 9 sides is called a nonagon. An octagon has 8 sides, a decagon has 10 sides, and a heptagon has 7 sides, so each names a different number of sides from the 9 given. Answer: nonagon.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (a) 9 — A cube has 9 planes of symmetry in total: 3 that pass through the middles of pairs of opposite faces, and 6 more that pass through pairs of opposite edges diagonally. A candidate who counts only the 3 face-to-face planes — which is correct for a cuboid with three different edge lengths, but forgets that a cube's equal edges create 6 more diagonal planes — answers 3. A candidate who counts only the 6 diagonal planes and forgets the 3 face-to-face ones answers 6. A candidate who confuses the number of planes of symmetry with the number of edges on a cube answers 12. The correct total for a cube is 9.
- (d) 2π cm — The arc is a fraction of the whole circumference. The fraction is 72 ÷ 360 = 1/5 of the circle, and the full circumference is 2 × π × 5 = 10π cm. So the arc length is 1/5 × 10π = 2π cm. Taking the whole circumference and forgetting the fraction gives 10π cm. Using 72 ÷ 180 instead of 72 ÷ 360 gives 4π cm. Treating the 5 cm as a diameter instead of a radius gives π cm.
- (d) 125° — Method: two angles that sit next to each other at a crossing point lie on a straight line, so they add up to 180°; the angle that faces the given one across the point is the equal one, and that is not the angle asked for here. Working: 180° − 55° = 125°. Answer: 125°. The distractors: 55° is the angle vertically opposite the given one, taken by a candidate who reads “next to” as the facing angle and applies the equal-angles rule to the wrong pair; 35° comes from subtracting from 90°, treating the pair as complementary instead of as angles on a straight line; 90° comes from assuming that a line crossing a pair of parallel lines must meet them at right angles, which the question never says.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
Build your own mix at the worksheet builder.