Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (c) Reflex — Method: compare the measured angle to the key boundaries of 90 degrees, 180 degrees and 360 degrees. Working: 254 degrees is greater than 180 degrees but less than 360 degrees, so it lies in the reflex range. A student who answers obtuse knows the angle is bigger than 90 degrees but has not realised it is also bigger than 180 degrees; they may have worked with the smaller angle at the same point, 360 - 254 = 106 degrees, instead of the reading given. A student who answers acute has misread the scale and taken the reading as 54 degrees rather than 254 degrees. A student who answers right has guessed a commonly recognised angle type without comparing the size properly. Answer: reflex.
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (a) 28 cm — Method: the perimeter is the total distance round the outside, and a rhombus has four sides of equal length, so the perimeter is 4 × the side length. Working: 4 × 7 = 28. Answer: 28 cm. The distractors: 14 cm comes from 2 × 7, adding only one pair of sides and forgetting that a rhombus has two pairs; 49 cm comes from working out 7 × 7, which is the calculation for the area of a square rather than a distance round the outside; 11 cm comes from adding the side length to the number of sides, 7 + 4, instead of multiplying them.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (a) Infinitely many — Method: a radius is any straight line from the centre of a circle to a point on the circle, so counting the radii means counting the possible end points, and those end points are the points of the circle itself. Working: a circle is a continuous curve, so between any two points on it there is always another point; the supply of end points therefore never runs out, and each end point gives one radius. Every one of those radii is the same length, because equal distance from the centre is what makes the curve a circle in the first place. Answer: Infinitely many. The distractors: Exactly one comes from treating a radius as a single fixed line, because a textbook diagram usually shows only one drawn in; Exactly two comes from picturing a diameter and counting the two halves it is made of; Exactly four comes from picturing the circle cut into quarters by two perpendicular diameters and counting the four radii that appear in that picture.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (b) 22 — Method: add the two drawn lengths together first, then apply the scale to the total. Working: 3 cm + 2.5 cm = 5.5 cm; 5.5 cm × 4 = 22 m. A student who answers 10 has only converted one of the two sections (2.5 cm × 4) and forgotten the other. A student who answers 5.5 has added the two drawn lengths but forgotten to apply the scale at all. A student who answers 44 has doubled the correct answer, effectively applying the scale twice. Answer: 22 m.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (a) Two sides equal, with the angle between them equal — Method: recall what each letter in SAS stands for, and the order they must appear in. Working: SAS stands for Side, Angle, Side — two pairs of equal sides, with the equal angle positioned between them. Options: 'two sides and any one angle' describes SSA, which is not valid, since the angle must specifically be the included one; 'two angles with the side between them' describes ASA, a different condition; 'all three pairs of sides' describes SSS, also different. Answer: two sides equal, with the angle between them equal.
Build your own mix at the worksheet builder.