Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (c) x — By convention, the side opposite a vertex is labelled with the lowercase version of that vertex's letter, so the side opposite X is labelled x. y is the label for the side opposite Y, not X. z is the label for the side opposite Z, not X. X is the vertex's own uppercase letter — the convention specifically switches to lowercase for the side, so the uppercase letter on its own is not correct.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (b) angles on a straight line add up to 180° — 118° and 62° add up to 180°, matching the fact that angles on a straight line always add up to 180° — that is the reason the second angle is 62°. Angles round a point add up to 360° is a different fact, used for angles surrounding a single point, not two angles on a line. Vertically opposite angles are equal would make the second angle 118° too, not 62°. Angles in a triangle add up to 180° is a true fact, but it applies to the three angles inside a triangle, not two angles on a straight line.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
- (a) 60° — Method: the three angles of a triangle add up to 180°, so add the two known angles and subtract the total from 180°. Working: 50 + 70 = 120, then 180 − 120 = 60. Answer: 60°. The distractors: 120° is the sum of the two known angles, given as the answer instead of being subtracted from 180°; 110° comes from subtracting only the 70° angle from 180° and forgetting the 50° one; 240° comes from subtracting the sum from 360°, using the angles at a point rather than the angle sum of a triangle.
- (b) an arc of the same radius, centred at B — The perpendicular bisector construction needs two arcs of equal radius, one centred at each end of the segment — after the arc from A, the next step is an arc of exactly the same radius from B, so the two arcs cross at two points; the line through those two crossing points is the perpendicular bisector. "an arc of the same radius, centred at the midpoint of AB" is not possible yet, since the midpoint is only found once both arcs are drawn — it is the RESULT of the construction, not a step in it. "a smaller arc, centred at A again" gives two different-sized arcs from the same point, which never cross to give the bisector. "a straight line joining the ends of the first arc" only connects points on one arc, and locates nothing.
- (a) 110° — The angles in a quadrilateral add up to 360°. So 40° + 100° + W + W = 360°, giving 2W = 360° − 140° = 220°, so W = 110°. A pupil who works out 2W = 220° but forgets to divide by 2, since there are two equal angles W, gives 220°. A pupil who mistakenly uses the angle sum of a triangle, 180°, instead of 360°, gets 180° − 140° = 40°. A pupil who simply adds the two given angles together instead of subtracting from 360° gets 40° + 100° = 140°. The correct answer is 110°.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (d) 1.5 m — By Pythagoras' theorem, diagonal² = 1.2² + 0.9² = 1.44 + 0.81 = 2.25, so diagonal = √2.25 = 1.5 m. 2.1 m comes from simply adding the two sides (1.2 + 0.9) instead of using Pythagoras' theorem. 0.3 m comes from subtracting the two sides (1.2 − 0.9) instead. 2.25 m comes from correctly finding 1.2² + 0.9² = 2.25 but forgetting to take the square root at the end.
- (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (b) No, it needs one more square — A closed cube has exactly 6 faces, so its net must be made of exactly 6 identical squares, arranged so each one unfolds to a separate face with none overlapping. This net has only 5 squares, so it is one square short and cannot be folded into a closed cube. Choosing 'Yes, it folds into a cube' ignores that a cube needs 6 faces, not 5. Choosing 'No, it has one square too many' miscounts in the wrong direction — 5 is one too FEW, not one too many. Choosing 'Yes, but only if two squares overlap' is not a valid net: a net's faces must not overlap when folded.
Build your own mix at the worksheet builder.