Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (d) 180 — Method: bearings are measured clockwise from north and written using three figures. Working: south is a half turn (180°) clockwise from north. A student who answers 090 has confused south with east. A student who answers 270 has confused south with west. A student who answers 018 has written the correct digits in the wrong order. Answer: 180.
- (b) angle B = angle E — AB and BC meet at vertex B, so the angle INCLUDED between them is angle B; making angle B = angle E completes SAS. Angle A sits between AB and AC, not between AB and BC, so it is not the included angle needed for SAS here. Angle C sits between BC and CA, not between AB and BC, so it is not included either. AC = DF would give a third pair of equal sides, which proves congruence by SSS instead of SAS.
- (c) (2, 4) and (6, 4) — Method: two points lie on the same horizontal line when they stand at the same height above the x-axis, and a point's height is given by its y-coordinate, the second number in the bracket. Working: compare the second numbers in each pair. For (3, 5) and (3, 8) they are 5 and 8, which differ. For (1, 2) and (2, 1) they are 2 and 1, which differ. For (0, 0) and (1, 1) they are 0 and 1, which differ. For (2, 4) and (6, 4) they are 4 and 4, which agree, so only that pair lies on a horizontal line. Answer: (2, 4) and (6, 4). The distractors: (3, 5) and (3, 8) comes from swapping horizontal for vertical, since equal x-coordinates place two points one above the other; (1, 2) and (2, 1) comes from looking for the same pair of numbers rather than for the same y-coordinate; (0, 0) and (1, 1) comes from reading 'horizontal' as simply 'in a straight line', which any two points are.
- (b) No, it needs one more square — A closed cube has exactly 6 faces, so its net must be made of exactly 6 identical squares, arranged so each one unfolds to a separate face with none overlapping. This net has only 5 squares, so it is one square short and cannot be folded into a closed cube. Choosing 'Yes, it folds into a cube' ignores that a cube needs 6 faces, not 5. Choosing 'No, it has one square too many' miscounts in the wrong direction — 5 is one too FEW, not one too many. Choosing 'Yes, but only if two squares overlap' is not a valid net: a net's faces must not overlap when folded.
- (a) a circle of radius 4 cm, centred at O — Every point exactly 4 cm from a fixed point O sweeps out a full circle of radius 4 cm centred at O — that is the definition of this locus. "a straight line 4 cm long, starting at O" only covers points in one direction, not every direction. "a square with sides of 4 cm, centred at O" would only touch the true locus at a few points on its perimeter, since most of a square's edge is not 4 cm from its centre. "two points, each 4 cm from O" comes from picturing only the points directly left and right of O, forgetting every other direction round it.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (d) Yes, by the AA condition — Method: similarity is decided by the angles, and because the three angles of a triangle add up to 180°, two matching pairs force the third pair to match as well. Working: the angles at A and D are both 40° and the angles at B and E are both 70°, so the third angles are both 180° − 40° − 70° = 70° and all three pairs are equal. Two pairs were enough, and that is the AA condition. Answer: yes, by the AA condition. The distractors: 'Yes, by the SSS condition' names a condition about three pairs of sides in proportion, and the question gives no side lengths at all; 'No, because no side lengths are given' treats side information as necessary, which it is for congruence but not for similarity; 'No, because the triangles may be different sizes' turns the definition of similarity into an objection, since similar figures are allowed to differ in size and only their shape must match.
- (c) 0.5 — The real distance is 2 × 25000 = 50000 cm. Converting to metres, by dividing by 100, gives 500 m, and converting to kilometres, by dividing by 1000, gives 0.5 km. A candidate who divides the 50000 cm by 1000 in one go, applying the metres-to-kilometres factor straight to the centimetres, gets 50 km. A candidate who divides by 100 twice, treating 100 m as 1 km, gets 5 km. A candidate who slips one extra decimal place when converting 500 m to kilometres gets 0.05 km. The real distance is 0.5 km.
- (b) 270° — Bearings are measured clockwise from north (000°). Due north is 000°, due east is 090°, due south is 180° and due west is 270°. Choosing 090° gives the bearing for due east, not west. Choosing 180° gives the bearing for due south. Choosing 000° gives the bearing for due north.
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (d) 88° — Method: the three angles add up to 180°, and here it is the two equal base angles that are known, so take both of them away from 180°. Working: the two base angles come to 2 × 46° = 92°, and 180° − 92° = 88°. Answer: 88°. The distractors: 134° comes from subtracting only one base angle, 180° − 46°, and forgetting that there are two of them; 92° comes from doubling the base angle and stopping there, which is the two base angles together rather than the apex; 46° comes from assuming that all three angles of the triangle are equal to the one that is given.
Build your own mix at the worksheet builder.