Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 9 — A cube has 9 planes of symmetry in total: 3 that pass through the middles of pairs of opposite faces, and 6 more that pass through pairs of opposite edges diagonally. A candidate who counts only the 3 face-to-face planes — which is correct for a cuboid with three different edge lengths, but forgets that a cube's equal edges create 6 more diagonal planes — answers 3. A candidate who counts only the 6 diagonal planes and forgets the 3 face-to-face ones answers 6. A candidate who confuses the number of planes of symmetry with the number of edges on a cube answers 12. The correct total for a cube is 9.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) 12.56 cm² — Sector area = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 4² = 0.25 × 3.14 × 16 = 12.56 cm². (3.14 cm² comes from forgetting to square the radius; 50.24 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 6.28 cm² comes from using the arc length formula instead of the sector area formula.)
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (d) 15 cm — Arc length = (angle ÷ 360) × 2 × π × r. Here 120 ÷ 360 = 1/3, and 2 × 3.14 = 6.28, so 31.4 = (1/3) × 6.28 × r. Multiplying both sides by 3 gives 6.28 × r = 94.2, so r = 94.2 ÷ 6.28 = 15 cm. (5 cm comes from forgetting the angle fraction altogether and dividing the arc length by 2 × π alone: 31.4 ÷ 6.28 = 5; 30 cm comes from leaving out the factor of 2, dividing by (1/3) × 3.14 = 1.0467 instead of (1/3) × 6.28: 31.4 ÷ 1.0467 = 30; 7.5 cm comes from correctly finding a radius of 15 cm but then treating that 15 cm as a diameter and halving it.)
- (c) 34 cm — Method: a rectangle has two lengths and two widths, so the perimeter is 2 × (length + width). Working: 12 + 5 = 17, then 2 × 17 = 34. Answer: 34 cm. The distractors: 17 cm comes from adding one length and one width and stopping, which is only half of the way round; 24 cm comes from doubling the length alone, 2 × 12, and leaving the two widths out; 60 cm² comes from working out 12 × 5, which is the area of the photograph and carries a squared unit because two lengths have been multiplied.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (c) 12 cm — By Pythagoras' Theorem, QR² = PQ² + PR², so PR² = QR² − PQ² = 15² − 9² = 225 − 81 = 144. Square root: √144 = 12 cm.
- (b) Nonagon — Method: match the number of sides given to the correct polygon name. Working: a polygon with 9 sides is called a nonagon. An octagon has 8 sides, a decagon has 10 sides, and a heptagon has 7 sides, so each names a different number of sides from the 9 given. Answer: nonagon.
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
Build your own mix at the worksheet builder.