Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (c) 27 cm² — Area of a rectangle = length × width = 4.5 × 6 = 27 cm². A pupil who adds the two sides instead of multiplying gets 4.5 + 6 = 10.5 cm². A pupil who works out the perimeter instead of the area gets 2 × (4.5 + 6) = 21 cm². A pupil who rounds 4.5 up to 5 before multiplying gets 5 × 6 = 30 cm². The correct area is 27 cm².
- (d) 2π cm — The arc is a fraction of the whole circumference. The fraction is 72 ÷ 360 = 1/5 of the circle, and the full circumference is 2 × π × 5 = 10π cm. So the arc length is 1/5 × 10π = 2π cm. Taking the whole circumference and forgetting the fraction gives 10π cm. Using 72 ÷ 180 instead of 72 ÷ 360 gives 4π cm. Treating the 5 cm as a diameter instead of a radius gives π cm.
- (b) Right angle, equal hypotenuse, one more side — RHS requires a right angle in each triangle, equal hypotenuses, and one further pair of equal sides, so 'right angle, equal hypotenuse, one more side' is correct. 'Right angle, hypotenuse, one more angle' is wrong because it asks for an extra equal angle instead of an extra equal side, which RHS does not check. 'Two sides and the angle between them' describes SAS, not RHS, so it is wrong. 'Right angle and all three sides equal' describes SSS with an extra right-angle condition, asking for more information than RHS actually needs, so it is wrong.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (a) 12 — A cube has 6 square faces, 12 edges and 8 vertices. The edges are the straight lines where two faces meet: 4 edges around the top face, 4 edges around the bottom face, and 4 vertical edges joining them, giving 4 + 4 + 4 = 12. A candidate who counts the vertices instead of the edges answers 8. A candidate who counts the faces instead answers 6. A candidate who counts only the edges around the top face, forgetting the bottom face and the vertical edges, answers 4. The correct number of edges is 12.
- (b) 113.04 cm² — Sector area is (angle ÷ 360) × π × radius², and radius means the RADIUS, not the diameter: here the diameter is 24 cm, so the radius is 12 cm. The fraction is 90 ÷ 360 = 1/4, and 12² = 144, so the area is 0.25 × 3.14 × 144 = 113.04 cm². Using the diameter itself as if it were the radius gives 0.25 × 3.14 × 576 = 452.16 cm². Using the arc-length formula, 2 × π × radius, instead of the area formula gives 0.25 × 2 × 3.14 × 12 = 18.84 cm². Using the radius instead of its square gives 0.25 × 3.14 × 12 = 9.42 cm².
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (d) 180 — Method: bearings are measured clockwise from north and written using three figures. Working: south is a half turn (180°) clockwise from north. A student who answers 090 has confused south with east. A student who answers 270 has confused south with west. A student who answers 018 has written the correct digits in the wrong order. Answer: 180.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
Build your own mix at the worksheet builder.