Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (d) 452.16 cm² — Area = πr². Substitute r = 12: area = 3.14 × 12² = 3.14 × 144 = 452.16 cm².
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (c) 24 cm² — Method: the front elevation of a cuboid is a rectangle formed by the cuboid's length and its height, so its area is length × height. Working: 6 cm × 4 cm = 24 cm². Answer: 24 cm². The distractors: 12 cm² comes from using width × height (3 × 4) instead of length × height, mistaking the side elevation's dimensions for the front's. 18 cm² comes from using length × width (6 × 3), which gives the area of the plan view instead of the front elevation. 20 cm² comes from finding the perimeter of the front face instead of its area: 2 × (6 + 4) = 20.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (c) 15 — The exterior angle is 180° − 156° = 24°, and the number of sides of a regular polygon is 360° divided by the exterior angle, so 360 ÷ 24 = 15. 24° is the exterior angle itself, stopping one step before the final division. 17 comes from finding 15 correctly and then adding 2, muddling the exterior angle rule with the (n − 2) that appears in the interior angle sum formula. 7.5 comes from dividing 180 by the exterior angle instead of 360, using the angles on a straight line rather than the total of the exterior angles of a polygon.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (b) (3, 10) — Method: multiply every part of p by 2, then add the matching parts of q. Working: 2p = (4, 6); adding q gives top 4 + (−1) = 3 and bottom 6 + 4 = 10. Answer: 2p + q = (3, 10). A candidate who forgets to double p first, working out p + q instead, gets (1, 7). A candidate who doubles q instead of p, working out p + 2q, gets (0, 11). A candidate who subtracts q instead of adding it, working out 2p − q, gets (5, 2).
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
Build your own mix at the worksheet builder.