Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (a) 110° — Method: in a parallelogram the two angles at the ends of one side are co-interior angles between a pair of parallel sides, so they add up to 180°. Working: angle A + angle B = 180°, so angle B = 180° − 70° = 110°. Answer: 110°. The distractors: 70° comes from applying the rule for opposite angles of a parallelogram, which are equal, to two angles that are next to each other instead; 20° comes from treating the two angles as complementary and working out 90° − 70°; 290° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given, 360° − 70°.
- (a) 62° — Angle KPQ and angle MQP are co-interior (allied) angles between parallel lines, so they add up to 180°: angle MQP = 180° − 118° = 62°. 118° comes from treating the angles as equal, as if this were a corresponding or alternate angle pair, instead of using the co-interior rule. 90° comes from wrongly assuming the crossing line meets JK and LM at right angles. 59° comes from halving 118° instead of subtracting it from 180°.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (d) 18.8 cm — Arc length is a fraction of the full circumference. Here 120 ÷ 360 = 1/3, and the full circumference is 2 × 3.14 × 9 = 56.52 cm, so the arc is 56.52 ÷ 3 = 18.84 cm, which rounds to 18.8 cm. Forgetting the fraction and giving the full circumference rounds to 56.5 cm. Using 9 cm as a diameter instead of a radius gives an arc of 9.4 cm. Using 120 ÷ 180 instead of 120 ÷ 360 for the fraction gives an arc of 37.7 cm.
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (c) exterior angle = sum of the two interior opposite angles — Angle ACD is the exterior angle at C, and the exterior angle of a triangle is always equal to the sum of the two interior angles at the other two vertices — here, angle BAC and angle ABC — so angle ACD = 48° + 67° = 115°. "angles in a triangle add up to 180°" is a true fact, but on its own it only gives the INTERIOR angle at C (180 − 48 − 67 = 65°), not the exterior angle 115° — reaching 115° that way still needs a further step. "angles on a straight line add up to 180°" is the fact that links the interior and exterior angles at C to each other, not the fact that gives 115° directly from the two OTHER angles. "exterior angle is always double the smallest angle" is not a genuine angle fact: double the smallest angle here is 48° × 2 = 96°, not 115°.
- (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
Build your own mix at the worksheet builder.