Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (a) 750 — Method: to change kilograms to grams, multiply by 1000. Working: 0.75 × 1000 = 750. Answer: 750 g. A candidate who multiplies by 100 instead of 1000 gets 75. A candidate who multiplies by 10000 instead of 1000 gets 7500. A candidate who divides by 1000 instead of multiplying gets 0.00075.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) 1.2 m² — Method: an area in square metres needs lengths in metres, so convert first and then multiply. Working: 100 cm = 1 m, so 150 cm = 1.5 m and 80 cm = 0.8 m, and the area = 1.5 × 0.8 = 1.2 m². Answer: 1.2 m². The same result comes from working in centimetres: 150 × 80 = 12 000 cm², and a square metre is a square of side 100 cm, so 100 × 100 = 10 000 cm² make one square metre and 12 000 ÷ 10 000 = 1.2. Dividing the 12 000 cm² by 100 instead, as though a square metre held only 100 square centimetres, gives 120 m²; dividing by 1000 gives 12 m². Working out the perimeter rather than the area gives 1.5 + 0.8 + 1.5 + 0.8 = 4.6, which is a length and not an area.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
Build your own mix at the worksheet builder.