Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) (−2, 0) — A 180° rotation about a centre (a, b) maps (x, y) to (2a − x, 2b − y). Here that gives (2 × 1 − 4, 2 × 1 − 2) = (−2, 0). A pupil who rotates about the origin instead of (1, 1) gets (−4, −2). A pupil who adds the centre's coordinates instead of applying the rotation formula gets (4 + 1, 2 + 1) = (5, 3). A pupil who just subtracts the centre's coordinates from E's, without doubling and reversing, gets (4 − 1, 2 − 1) = (3, 1). The correct image is (−2, 0).
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (d) 2π cm — Arc length is the fraction θ/360 of the full circumference, 2πr. Substitute θ = 60 and r = 6: 60 out of 360 is one sixth, and the full circumference is 2π × 6 = 12π. One sixth of 12π is 2π, so the arc length is 2π cm. Choosing 12π cm uses the full circumference without scaling it down by the fraction θ/360 first. Choosing 6π cm applies the SECTOR AREA formula, (θ/360) × πr², instead of the arc length formula — that calculation actually gives 6π, which is the area in cm², not a length. Choosing π cm uses πr instead of 2πr, missing the factor of 2 in the circumference formula.
- (b) 10 — Corresponding angles are equal, so 5x + 4 = 3x + 24. Subtracting 3x from both sides gives 2x + 4 = 24, then subtracting 4 gives 2x = 20, so x = 10. 14 comes from adding the constants, 4 + 24, instead of subtracting them when rearranging. 19 comes from treating the angles as co-interior (summing to 180°): 5x + 4 + 3x + 24 = 180 gives 8x = 152, so x = 19. 20 correctly reaches 2x = 20 but stops without dividing by 2.
- (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (c) 1 — Method: the instruction states that a curved surface counts as a face, so count the surfaces of the sphere on that basis. Working: a sphere has exactly one continuous curved surface and no flat surfaces at all. A student who answers 0 has ignored the instruction and refused to count the curved surface. A student who answers 2 has confused the sphere with a cylinder, which has two flat circular faces. A student who answers 3 has imagined extra hidden surfaces that do not exist. Answer: 1 face.
- (a) radius — The distance from the centre O to any point on the circle is the radius. The diameter is the distance right across the circle, through the centre, from one side to the other — twice the radius, not the same measurement. The circumference is the total distance around the circle, not from the centre. A chord is a line joining two points on the circle that does not have to pass through the centre at all.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
Build your own mix at the worksheet builder.