Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) A cuboid — Method: work out which solid has flat faces only, no curved surfaces and no point where edges meet, since only that gives rectangles for all three views. Working: a solid whose plan, front elevation and side elevation are all rectangles has three pairs of flat rectangular faces meeting at right angles — that is a cuboid. Answer: a cuboid. The distractors: a cylinder is wrong because its plan view (from above) is a circle, not a rectangle. A cone is wrong because its plan view is a circle and its front and side elevations are triangles. A square-based pyramid is wrong because its front and side elevations come to a point at the apex, giving triangles rather than rectangles, even though its plan view could be a square.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (c) (5, 1) — Moving right increases the x-coordinate, and moving down decreases the y-coordinate, so (2, 5) becomes (2 + 3, 5 − 4) = (5, 1). (5, 9) comes from adding 4 to the y-coordinate instead of subtracting, as if the point moved up rather than down. (−1, 1) comes from subtracting 3 from the x-coordinate instead of adding, as if the point moved left rather than right. (2, 1) keeps the x-coordinate unchanged and only applies the vertical move, forgetting the horizontal move altogether.
- (d) 38 m² — The two fences meet at a right angle, so the rope sweeps a quarter of a circle: 90 ÷ 360 = 1/4. Grazing area = (90 ÷ 360) × 3.14 × 7² = 0.25 × 153.86 = 38.465 m², which rounds to 38 m². (5 m² comes from forgetting to square the rope length; 154 m² comes from finding the area of a full circle and forgetting the angle fraction; 11 m² comes from using the arc length formula instead of the sector area formula.)
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (d) (−4, −3) — Reflecting in the y-axis keeps the y-coordinate the same and changes the sign of the x-coordinate, so (4, −3) maps to (−4, −3). "(4, 3)" changes the sign of the y-coordinate instead, which is what happens when reflecting in the x-axis. "(−4, 3)" changes the sign of both coordinates, which is the result of a rotation of 180° about the origin, not a reflection in the y-axis. "(3, −4)" swaps the two coordinates around instead of reflecting either of them.
- (a) $\binom{4}{4}$ — A movement to the right is a positive top number and a movement up is a positive bottom number, so 4 right and 4 up gives $\binom{4}{4}$. $\binom{4}{-4}$ wrongly gives the vertical movement a negative sign, as if it were downward. $\binom{-4}{4}$ wrongly gives the horizontal movement a negative sign, as if it were leftward. $\binom{-4}{-4}$ gets both signs wrong, as if the translation were left and down.
- (c) (2, 4) and (6, 4) — Method: two points lie on the same horizontal line when they stand at the same height above the x-axis, and a point's height is given by its y-coordinate, the second number in the bracket. Working: compare the second numbers in each pair. For (3, 5) and (3, 8) they are 5 and 8, which differ. For (1, 2) and (2, 1) they are 2 and 1, which differ. For (0, 0) and (1, 1) they are 0 and 1, which differ. For (2, 4) and (6, 4) they are 4 and 4, which agree, so only that pair lies on a horizontal line. Answer: (2, 4) and (6, 4). The distractors: (3, 5) and (3, 8) comes from swapping horizontal for vertical, since equal x-coordinates place two points one above the other; (1, 2) and (2, 1) comes from looking for the same pair of numbers rather than for the same y-coordinate; (0, 0) and (1, 1) comes from reading 'horizontal' as simply 'in a straight line', which any two points are.
- (a) 65° — Method: a line that divides an angle into two equal parts gives each part half of the original angle, so halve 130°. Working: 130 ÷ 2 = 65. Answer: 65°. The distractors: 130° is the whole of angle ABC, written down without halving it; 50° comes from working out 180 − 130, using the angles on a straight line instead of dividing the angle in two; 32.5° comes from dividing by 4 instead of by 2, as though the line split the angle into four equal parts.
- (c) 18 — Method: divide the real length by 5 to find how many 'units' of 5 m it contains, then multiply by 2 cm for each unit. Working: 45 ÷ 5 = 9, so the real bridge is 9 lots of 5 m; each lot is represented by 2 cm on the model, so the model length is 9 × 2 = 18 cm. Options: 9 comes from stopping after the division, without multiplying by the 2 cm per unit; 90 comes from multiplying the real length by 2 directly, without dividing by 5 first; 4.5 comes from dividing by 5 and then dividing by 2 again, instead of multiplying by 2. Answer: 18.
Build your own mix at the worksheet builder.