Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 48° — Angles on a straight line add up to 180°, so angle ABD + angle DBC = 180°. 180° − 132° = 48°, so angle DBC = 48°. A student who uses angles around a point (360°) instead of a straight line (180°) finds 360° − 132° = 228°. A student who halves angle ABD by mistake, thinking DBC must be half of ABD, gets 132° ÷ 2 = 66°.
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (c) The midpoint of AB — M is a single point lying exactly halfway along the straight line AB, so 'the midpoint of AB' correctly describes it. 'The vertex of AB' is wrong because a vertex is a corner point where two edges or lines meet, which does not apply to a point on a single straight line. 'A perpendicular of AB' is wrong because perpendicular describes two lines meeting at right angles, not a single point. 'A plane of AB' is wrong because a plane is a flat two-dimensional surface, not a point.
- (a) (2, 6) — To translate by the vector (−3, 4), add −3 to the x-coordinate and add 4 to the y-coordinate: (5 − 3, 2 + 4) = (2, 6). A pupil who adds 3 instead of subtracting for the x-coordinate gets (8, 6). A pupil who swaps the x- and y-components of the vector gets (5 + 4, 2 − 3) = (9, −1). A pupil who subtracts both components instead of adding the y-component gets (5 − 3, 2 − 4) = (2, −2). The correct image is (2, 6).
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (b) 3 — A cuboid with all different edge lengths has three planes of symmetry: one parallel to each pair of opposite faces, cutting the solid exactly in half. Choosing 9 is the number of planes of symmetry a CUBE has (where all edges are equal) — this cuboid's edges are all different, so it has fewer. Choosing 1 counts only one of the three planes and forgets the other two, each parallel to a different pair of faces. Choosing 6 double-counts each of the three planes, as if counting each one from both sides.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (d) $\binom{−5}{−3}$ — Left is a negative horizontal move and down is a negative vertical move, so the vector is $\binom{−5}{−3}$. $\binom{5}{−3}$ comes from treating 'left' as a positive move. $\binom{−5}{3}$ comes from treating 'down' as a positive move. $\binom{−3}{−5}$ comes from swapping the horizontal and vertical components.
- (d) 2 h 18 min — Method: count on from the departure time in whole steps, rather than subtracting the two clock readings as if they were ordinary decimals. Working: from 08:47 to 09:00 is 13 minutes; from 09:00 to 11:00 is 2 hours; from 11:00 to 11:05 is a further 5 minutes. 13 + 5 = 18, so the journey lasts 2 hours and 18 minutes. Answer: 2 h 18 min. Subtracting as decimals gives 11.05 − 8.47 = 2.58 and the false reading 2 h 58 min, because an hour holds 60 minutes and not 100. Taking the minutes the wrong way round, 47 take away 5, gives 2 h 42 min. Counting the hours as 11 − 8 = 3 and then attaching the 18 minutes gives 3 h 18 min.
- (b) an arc of the same radius, centred at B — The perpendicular bisector construction needs two arcs of equal radius, one centred at each end of the segment — after the arc from A, the next step is an arc of exactly the same radius from B, so the two arcs cross at two points; the line through those two crossing points is the perpendicular bisector. "an arc of the same radius, centred at the midpoint of AB" is not possible yet, since the midpoint is only found once both arcs are drawn — it is the RESULT of the construction, not a step in it. "a smaller arc, centred at A again" gives two different-sized arcs from the same point, which never cross to give the bisector. "a straight line joining the ends of the first arc" only connects points on one arc, and locates nothing.
- (c) RHS — Method: check which basic congruence condition matches the facts given — a right angle, the hypotenuse, and one other side, in both triangles. Working: both triangles have a right angle (at M and Q), the hypotenuse is given for both (LN = PR = 15 cm), and one other side is given for both (LM = PQ = 9 cm) — this is exactly Right angle, Hypotenuse, Side. Options: SAS would need the given angle to sit between the two given sides, but the right angle at M is not between LM and LN, since LN is the hypotenuse, opposite the right angle; SSS would need three sides given in each triangle, but only two sides are known here; ASA would need two angles and the side between them, but only one angle is given. Answer: RHS.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
Build your own mix at the worksheet builder.