Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 88° — Method: the three angles add up to 180°, and here it is the two equal base angles that are known, so take both of them away from 180°. Working: the two base angles come to 2 × 46° = 92°, and 180° − 92° = 88°. Answer: 88°. The distractors: 134° comes from subtracting only one base angle, 180° − 46°, and forgetting that there are two of them; 92° comes from doubling the base angle and stopping there, which is the two base angles together rather than the apex; 46° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (d) 8 — A cuboid is a 3D shape with 6 rectangular faces, 12 edges and 8 vertices (corners). Counting the corners of a cuboid gives 8. A candidate who mixes up vertices with faces answers 6. A candidate who mixes up vertices with edges answers 12. A candidate who counts only the 4 corners of the top face, forgetting the 4 corners of the bottom face, answers 4. The correct number of vertices is 8.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (a) 59° — Method: the three angles of a triangle add up to 180°, and in an isosceles triangle the two angles opposite the equal sides are equal, so take the known angle away from 180° and share what is left equally between the other two. Working: 180° − 62° = 118°, and 118° ÷ 2 = 59°. Answer: 59°. The distractors: 118° comes from taking 62° from 180° and stopping there, which gives the two angles together rather than one of them; 31° comes from halving the 62° that is given instead of halving what is left; 62° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (b) (12, −8) — Method: to multiply a column vector by a number, multiply every part of the vector by that number. Working: top number 4 × 3 = 12; bottom number 4 × (−2) = −8. Answer: 4a = (12, −8). A candidate who adds 4 to each part instead of multiplying gets (7, 2). A candidate who multiplies only the top number by 4 and leaves the bottom number unchanged gets (12, −2). A candidate who multiplies only the bottom number by 4 and leaves the top number unchanged gets (3, −8).
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (c) Square — Because the cut is parallel to the square base, it produces a shape that is similar to the base — the same shape, scaled down — so it is also a square, with four equal sides, smaller than the base. A candidate who looks at the sloped triangular faces instead of at the horizontal cut answers triangle. A candidate who pictures a slanted cut, which would shorten one pair of sides, answers trapezium, but a cut parallel to the base scales all four sides by the same amount. A candidate who counts an extra side, perhaps including an edge of the base, answers pentagon. The cross-section is a square.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (a) 150° — The arc length is the same fraction of the circumference as the angle is of 360°. The full circumference is 2 × 3.14 × 6 = 37.68 cm, so the angle is 15.7 ÷ 37.68 × 360 = 150°. Treating the 6 cm as a diameter instead of a radius gives a circumference of 18.84 cm and an angle of 300°. Using π = 3 instead of the given 3.14 gives a circumference of 36 cm and an angle of 157°. Treating the fraction 15.7 ÷ 37.68 as being out of 100 rather than 360 gives about 42°.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (c) 52° — When two straight lines cross, the angles opposite each other at the crossing point are vertically opposite and are equal. Ray OQ is opposite ray OP and ray OS is opposite ray OR, so angle QOS is vertically opposite angle POR. Therefore angle QOS = 52°.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
Build your own mix at the worksheet builder.