Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (a) Wrong: multiply by angle ÷ 360, not divide by it. — The arc length is the fraction angle ÷ 360 of the circumference, and that fraction is MULTIPLIED by the circumference — it is never divided by the angle itself. So Priya's method, dividing by the angle, is wrong, and the correct statement names both the fraction and the multiplication. Saying she is correct accepts her wrong division. Saying the arc length is the full circumference multiplied by the angle in degrees, with no division at all, drops the 360 that turns the angle into a fraction. Saying the arc length is the radius multiplied by the angle in degrees swaps the circumference for the radius, which is a different and, in degrees, incorrect formula.
- (b) angles on a straight line add up to 180° — 118° and 62° add up to 180°, matching the fact that angles on a straight line always add up to 180° — that is the reason the second angle is 62°. Angles round a point add up to 360° is a different fact, used for angles surrounding a single point, not two angles on a line. Vertically opposite angles are equal would make the second angle 118° too, not 62°. Angles in a triangle add up to 180° is a true fact, but it applies to the three angles inside a triangle, not two angles on a straight line.
- (d) DE = 8 cm — Method: use the stated correspondence ABC ≅ DEF to work out which side in DEF matches the known side AB in ABC. Working: the correspondence sends A to D, B to E and C to F, so AB corresponds to DE; the right angles at B and E and the equal hypotenuses AC = DF = 17 cm are already given, so DE = 8 cm supplies the third ingredient — Right angle, Hypotenuse, Side. Options: EF = 8 cm matches AB to the wrong side, since EF corresponds to BC, and BC = √(17² − 8²) = 15 cm, not 8 cm; BC = 8 cm states something about triangle ABC rather than the missing fact about DEF, and it is false as well, since BC = 15 cm; angle D = angle A does follow once the triangles are congruent, but RHS is completed by a matching side, not by a matching angle. Answer: DE = 8 cm.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (b) 28 cm² — Area of a trapezium = (sum of parallel sides) ÷ 2 × height. Sum of parallel sides = 5.6 + 8.4 = 14 cm. Half of that is 14 ÷ 2 = 7 cm. Area = 7 × 4 = 28 cm². A pupil who forgets to halve gets 14 × 4 = 56 cm². A pupil who uses only the longer parallel side, as if this were a rectangle, gets 8.4 × 4 = 33.6 cm². A pupil who subtracts the parallel sides instead of adding them gets (8.4 − 5.6) ÷ 2 × 4 = 1.4 × 4 = 5.6 cm². The correct area is 28 cm².
- (c) √3/2 — Method: sin 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2 and base 1, and Pythagoras gives its height as √3 because 2² − 1² = 3. Working: sine is the opposite side over the hypotenuse, the side opposite the 60° angle is the height √3, and the hypotenuse is 2, so sin 60° = √3 ÷ 2. Answer: sin 60° = √3/2. Swapping sine for cosine at this angle gives cos 60° = 1/2; taking the value from the other special triangle, the right-angled isosceles one, gives sin 45° = √2/2; and reading the tangent row instead of the sine row gives tan 60° = √3.
- (a) 59° — Method: the three angles of a triangle add up to 180°, and in an isosceles triangle the two angles opposite the equal sides are equal, so take the known angle away from 180° and share what is left equally between the other two. Working: 180° − 62° = 118°, and 118° ÷ 2 = 59°. Answer: 59°. The distractors: 118° comes from taking 62° from 180° and stopping there, which gives the two angles together rather than one of them; 31° comes from halving the 62° that is given instead of halving what is left; 62° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) points the same distance from A as from B — The perpendicular bisector of AB is, by definition, the locus of every point equidistant from A and B — any point on it forms two congruent right-angled triangles with A and B, which is exactly the property the construction guarantees. "points as far from A as the length AB" describes a circle centred at A with radius AB, not a bisector. "the single point exactly halfway along AB" names only the midpoint, one point, not the whole locus the construction produces. "points twice as far from A as from B" describes a different curve entirely, not a straight line construction.
Build your own mix at the worksheet builder.