Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) SAS — Method: a congruence condition is named by the parts that are given equal and the order in which they sit round the triangle, so count the sides and the angles first. Working: AB = DE and AC = DF are two pairs of equal sides, and the equal angle at A and D lies between AB and AC, so the given parts read side, included angle, side. Answer: SAS. The distractors: SSS needs three pairs of equal sides, and the third pair, BC and EF, is not given — it follows from the proof rather than being part of it; ASA reads the two equal sides as two equal angles, swapping which facts are which; RHS applies only when the triangles contain a right angle and the equal pair includes the hypotenuse, and nothing here says the angle at A is 90°.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (c) (2, 4) and (6, 4) — Method: two points lie on the same horizontal line when they stand at the same height above the x-axis, and a point's height is given by its y-coordinate, the second number in the bracket. Working: compare the second numbers in each pair. For (3, 5) and (3, 8) they are 5 and 8, which differ. For (1, 2) and (2, 1) they are 2 and 1, which differ. For (0, 0) and (1, 1) they are 0 and 1, which differ. For (2, 4) and (6, 4) they are 4 and 4, which agree, so only that pair lies on a horizontal line. Answer: (2, 4) and (6, 4). The distractors: (3, 5) and (3, 8) comes from swapping horizontal for vertical, since equal x-coordinates place two points one above the other; (1, 2) and (2, 1) comes from looking for the same pair of numbers rather than for the same y-coordinate; (0, 0) and (1, 1) comes from reading 'horizontal' as simply 'in a straight line', which any two points are.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (c) (6, 2) — Method: add the vector's components to the point's coordinates, x-component to x, y-component to y. Working: A′ = (2 + 4, 3 + (−1)) = (6, 2). Options: (6, 4) comes from adding the size of the y-component, 1, instead of subtracting it; (1, 7) comes from swapping the components, adding the y-component (−1) to the x-coordinate and the x-component (4) to the y-coordinate; (−2, 4) comes from reversing the sign of both components, using the vector (−4, 1) instead of (4, −1). Answer: (6, 2).
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (d) They are always equal to each other — Method: label the four angles a, b, c, d in order around the crossing point, then use the fact that neighbouring angles lie on a straight line. Working: a and b lie on a straight line, so a + b = 180°; b and c also lie on a straight line, so b + c = 180°. Both a and c are therefore 180° minus b, which forces a = c. Answer: a pair of vertically opposite angles is always equal to each other. The distractors: the claim that each is 90° holds only when the two lines happen to be perpendicular, so it is not always true; the claim that they add to 180° confuses the opposite pair with the neighbouring pair that lies along a straight line, and again holds only in the perpendicular case; the claim that they add to 360° uses the total of all four angles at the point rather than of the opposite pair.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
- (a) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs, and a kite and rhombus are defined by side lengths, not by having only one pair of parallel sides.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (c) SSA — Method: recall the four basic congruence criteria for triangles and compare them with each option. Working: the four basic conditions are SSS, SAS, ASA and RHS. SSA (two sides and a non-included angle) is not one of them, because knowing two sides and an angle that is not between them does not always fix a unique triangle. Options: SSS, ASA and RHS are each genuine congruence conditions, so none of them is the correct answer to 'which is NOT'. Answer: SSA.
Build your own mix at the worksheet builder.