Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (a) 3.75 km — To convert metres to kilometres, divide by 1000: 3750 ÷ 1000 = 3.75 km. Dividing by 100 instead of 1000 gives 37.5 km. Dividing by 10 instead of 1000 gives 375 km. Dividing by 10 000 instead of 1000 gives 0.375 km.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (b) $\binom{-6}{10}$ — Translating twice by the same vector doubles both components: 2 × $\binom{-3}{5}$ = $\binom{-6}{10}$. $\binom{-3}{5}$ forgets to double the vector at all, giving only one translation's worth. $\binom{-9}{15}$ trebles the vector instead of doubling it. $\binom{-6}{5}$ doubles only the top number and forgets to double the bottom number.
- (d) 15 cm² — Method: identify the length that is common to both views, since it is the box's length; then read off the width from the plan view and the height from the front elevation, and multiply those two measurements to find the area of the side elevation. Working: both rectangles share a side of 8 cm, which is the box's length; the plan view's other side gives a width of 5 cm, and the front elevation's other side gives a height of 3 cm. The side elevation is bounded by the width and the height: 5 cm × 3 cm = 15 cm². Answer: 15 cm². The distractors: 24 cm² comes from giving the area of the front elevation shown (8 cm × 3 cm) instead of working out a new rectangle for the side elevation. 40 cm² comes from giving the area of the plan view shown (8 cm × 5 cm) instead of working out the side elevation. 120 cm² comes from multiplying all three measurements together (8 cm × 5 cm × 3 cm), finding the volume of the box instead of the area of one face.
- (c) (6, 2) — Method: add the vector's components to the point's coordinates, x-component to x, y-component to y. Working: A′ = (2 + 4, 3 + (−1)) = (6, 2). Options: (6, 4) comes from adding the size of the y-component, 1, instead of subtracting it; (1, 7) comes from swapping the components, adding the y-component (−1) to the x-coordinate and the x-component (4) to the y-coordinate; (−2, 4) comes from reversing the sign of both components, using the vector (−4, 1) instead of (4, −1). Answer: (6, 2).
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (a) £157.00 — Area covered = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 400 = 0.25 × 1256 = 314 km². Charge = 314 × £0.50 = £157.00. (£7.85 comes from forgetting to square the radius, using 0.25 × 3.14 × 20 = 15.7 km² and then charging that; £628.00 comes from finding the area of a full circle, 3.14 × 400 = 1256 km², and forgetting the angle fraction before charging; £15.70 comes from using the arc length formula, 0.25 × 2 × 3.14 × 20 = 31.4, in place of the area, and charging that.)
- (a) isosceles trapezium — One pair of parallel sides, plus a separate pair of equal non-parallel sides, is exactly the definition of an isosceles trapezium — the shape the designer should draw. Parallelogram is wrong because a parallelogram needs BOTH pairs of opposite sides parallel, but only one pair is parallel here. Kite is wrong because a kite has two separate pairs of adjacent equal sides and no requirement for any sides to be parallel, a different combination of properties. Rhombus is wrong because a rhombus needs all four sides equal, but the description only makes two of the four sides equal to each other.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (d) 5 — A square-based pyramid has four vertices at the corners of the square base, plus one more vertex at the apex where the four triangular faces meet: 4 + 1 = 5 vertices. Choosing 8 counts the edges instead of the vertices. Choosing 4 counts only the base corners and forgets the apex at the top. Choosing 6 is the vertex count of a triangular prism, not a square-based pyramid.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (d) √3 — tan 60° = √3 — one of the exact values you need to know without a calculator. √3/2 is the exact value of sin 60° and of cos 30°, not tan 60°. 1/√3 is the exact value of tan 30°, the reciprocal-angle case. 3 comes from squaring √3 instead of reading off tan 60° itself.
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
Build your own mix at the worksheet builder.