Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (a) 6 cm — Method: a diameter runs right across a circle through its centre, so it is made of two radii laid end to end, which gives diameter = 2 × radius. Working: the radius is 3 cm, so the diameter is 2 × 3 = 6 cm. Answer: 6 cm. The distractors: 1.5 cm comes from dividing by 2 instead of multiplying by it, which is the relationship applied in the wrong direction; 3 cm comes from copying the radius straight down, treating the two words as names for the same measurement; 5 cm comes from adding 2 to the radius instead of multiplying the radius by 2.
- (c) 27 cm² — Area of a rectangle = length × width = 4.5 × 6 = 27 cm². A pupil who adds the two sides instead of multiplying gets 4.5 + 6 = 10.5 cm². A pupil who works out the perimeter instead of the area gets 2 × (4.5 + 6) = 21 cm². A pupil who rounds 4.5 up to 5 before multiplying gets 5 × 6 = 30 cm². The correct area is 27 cm².
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (c) exterior angle = sum of the two interior opposite angles — Angle ACD is the exterior angle at C, and the exterior angle of a triangle is always equal to the sum of the two interior angles at the other two vertices — here, angle BAC and angle ABC — so angle ACD = 48° + 67° = 115°. "angles in a triangle add up to 180°" is a true fact, but on its own it only gives the INTERIOR angle at C (180 − 48 − 67 = 65°), not the exterior angle 115° — reaching 115° that way still needs a further step. "angles on a straight line add up to 180°" is the fact that links the interior and exterior angles at C to each other, not the fact that gives 115° directly from the two OTHER angles. "exterior angle is always double the smallest angle" is not a genuine angle fact: double the smallest angle here is 48° × 2 = 96°, not 115°.
- (a) arc — A curved part of a circle's circumference, between two points, is called an arc. A chord is the straight line joining those two points, not the curved part. A segment is the region enclosed between a chord and an arc, and a sector is the region enclosed between two radii and an arc — both segment and sector are regions, not curved lengths.
- (d) 6.4 cm — The scale factor from the larger sign to the smaller sign is 4 ÷ 9, so the smaller side is 14.4 × 4 ÷ 9 = 6.4 cm. The distractor 32.4 cm comes from using the ratio the wrong way round, 14.4 × 9 ÷ 4 = 32.4. The distractor 9.4 cm comes from subtracting the difference between the ratio numbers (9 − 4 = 5) from the given length, 14.4 − 5 = 9.4. The distractor 3.6 cm comes from dividing the given length by 4 only, 14.4 ÷ 4 = 3.6, without also using the other ratio number.
- (b) 360 cm² — Method: the total surface area is the square base plus the four triangular faces, and the height used for a triangular face is the slant height of 13 cm, not the vertical height of 12 cm. Working: the base is 10 × 10 = 100 cm²; one triangular face is (10 × 13) ÷ 2 = 65 cm², so four faces give 4 × 65 = 260 cm²; the total is 100 + 260 = 360. Answer: 360 cm². The distractors: 260 cm² comes from adding the four triangular faces and leaving out the base; 340 cm² comes from using the vertical height of 12 cm as the height of each triangle, 100 + 4 × 60; 620 cm² comes from working out each face as 10 × 13 without halving, 100 + 4 × 130.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (d) 1 — At 45° the right-angled isosceles triangle has both shorter sides equal, so tan 45° = opposite ÷ adjacent = 1 ÷ 1 = 1. 0 is the value of tan 0° (mixing up the two angles). √3 is the value of tan 60°. √3/3 (equivalent to 1/√3) is the value of tan 30°.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (d) 56.52 cm — Circumference = πd. Substitute d = 18: circumference = 3.14 × 18 = 56.52 cm.
Build your own mix at the worksheet builder.