Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (a) 8 — Method: two capacities can only be divided once they are written in the same unit. Working: there are 1000 ml in 1 litre, so the bottle holds 2 × 1000 = 2000 ml. Then 2000 ÷ 250 = 8. Answer: 8 glasses. Using 1 litre = 10 000 ml gives 20 000 ÷ 250 = 80. Dividing the two numbers as they stand, 250 ÷ 2 = 125, ignores the units altogether. Converting the glass into litres with the wrong factor, as though 250 ml were 2.5 litres, gives 2 ÷ 2.5 = 0.8.
- (c) Square — Because the cut is parallel to the square base, it produces a shape that is similar to the base — the same shape, scaled down — so it is also a square, with four equal sides, smaller than the base. A candidate who looks at the sloped triangular faces instead of at the horizontal cut answers triangle. A candidate who pictures a slanted cut, which would shorten one pair of sides, answers trapezium, but a cut parallel to the base scales all four sides by the same amount. A candidate who counts an extra side, perhaps including an edge of the base, answers pentagon. The cross-section is a square.
- (a) Infinitely many — Method: a radius is any straight line from the centre of a circle to a point on the circle, so counting the radii means counting the possible end points, and those end points are the points of the circle itself. Working: a circle is a continuous curve, so between any two points on it there is always another point; the supply of end points therefore never runs out, and each end point gives one radius. Every one of those radii is the same length, because equal distance from the centre is what makes the curve a circle in the first place. Answer: Infinitely many. The distractors: Exactly one comes from treating a radius as a single fixed line, because a textbook diagram usually shows only one drawn in; Exactly two comes from picturing a diameter and counting the two halves it is made of; Exactly four comes from picturing the circle cut into quarters by two perpendicular diameters and counting the four radii that appear in that picture.
- (b) (6, 2) — The overall journey from house to park is the sum of the two vectors: top = 2 + 4 = 6, bottom = 5 + (−3) = 2, giving (6, 2). A candidate who subtracts the second vector from the first instead of adding gets (2 − 4, 5 − (−3)) = (−2, 8). A candidate who subtracts the other way round gets (4 − 2, −3 − 5) = (2, −8). A candidate who forgets the negative sign on the second vector's bottom number and adds 3 instead of −3 gets (6, 8). Because the journeys join end to end, the correct resultant vector is (6, 2).
- (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
- (a) Square — Method: two conditions are being asked for at once, so test each shape against both — the two diagonals must always be the same length as each other, and they must always meet at 90°. Working: in a rectangle the diagonals are equal but they meet at 90° only in the special case where the rectangle is also a rhombus; in a rhombus the diagonals do meet at 90° but they are of different lengths unless the rhombus is also a rectangle; the shape that satisfies both conditions for every example of it is the one that is both, and its diagonals are equal and perpendicular. Answer: the square. The distractors: the rectangle is where a candidate stops who tests only the equal-length condition and never checks the angle at the crossing; the rhombus is where a candidate stops who tests only the right-angle condition and never checks the two lengths; the parallelogram is chosen by a candidate who remembers that the diagonals of a parallelogram bisect each other and treats bisecting each other as being equal to each other, which is a different property.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
Build your own mix at the worksheet builder.