Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (d) √3 — tan 60° = √3 — one of the exact values you need to know without a calculator. √3/2 is the exact value of sin 60° and of cos 30°, not tan 60°. 1/√3 is the exact value of tan 30°, the reciprocal-angle case. 3 comes from squaring √3 instead of reading off tan 60° itself.
- (d) 15 cm — Arc length = (angle ÷ 360) × 2 × π × r. Here 120 ÷ 360 = 1/3, and 2 × 3.14 = 6.28, so 31.4 = (1/3) × 6.28 × r. Multiplying both sides by 3 gives 6.28 × r = 94.2, so r = 94.2 ÷ 6.28 = 15 cm. (5 cm comes from forgetting the angle fraction altogether and dividing the arc length by 2 × π alone: 31.4 ÷ 6.28 = 5; 30 cm comes from leaving out the factor of 2, dividing by (1/3) × 3.14 = 1.0467 instead of (1/3) × 6.28: 31.4 ÷ 1.0467 = 30; 7.5 cm comes from correctly finding a radius of 15 cm but then treating that 15 cm as a diameter and halving it.)
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (b) 270° — Bearings are measured clockwise from north (000°). Due north is 000°, due east is 090°, due south is 180° and due west is 270°. Choosing 090° gives the bearing for due east, not west. Choosing 180° gives the bearing for due south. Choosing 000° gives the bearing for due north.
- (d) £100.48 — Area of the rug = (angle ÷ 360) × π × r² = (180 ÷ 360) × 3.14 × 16 = 0.5 × 50.24 = 25.12 m². Cost = 25.12 × £4 = £100.48. (£200.96 comes from finding the area of a full circle, 3.14 × 16 = 50.24 m², and forgetting the angle fraction before costing it; £25.12 comes from forgetting to square the radius, using 0.5 × 3.14 × 4 = 6.28 m², and then costing that; £50.24 comes from using the arc length formula, 0.5 × 2 × 3.14 × 4 = 12.56, in place of the area, and costing that.)
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
Build your own mix at the worksheet builder.