Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 80 cm² — Method: a composite shape made of two rectangles that do not overlap has an area equal to the sum of the two rectangle areas, so work out each area and add them. Working: the first rectangle has area 12 × 4 = 48 cm² and the second has area 4 × 8 = 32 cm², so the total is 48 + 32 = 80. Answer: 80 cm². The distractors: 48 cm² comes from working out the larger rectangle only and treating it as the whole shape; 32 cm² comes from working out the smaller rectangle only; 28 cm comes from adding the four given lengths, 12 + 4 + 4 + 8, which is a distance rather than an area and so carries a plain centimetre unit.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
- (d) Alternate angles are equal — The two 65° angles are on opposite sides of the line that crosses the parallel lines, in the shape of a Z, so they are alternate angles, and alternate angles between parallel lines are always equal. Corresponding angles are equal too, but they sit in matching positions at each crossing point, in the shape of an F — a different pair from the one shown here. Co-interior angles add up to 180°, not to each other's value, and they lie between the parallel lines on the same side, in the shape of a C. Angles on a straight line add up to 180°, but that rule is about two angles at a single point on one line, not about a pair of angles formed where a line crosses two parallel lines.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (c) ABC ≅ XYZ — Method: match each vertex in ABC to its corresponding vertex in XYZ, using the equal sides and angles given, then write the letters in that matching order. Working: AB matches XY, BC matches YZ, and angle B matches angle Y, so A corresponds to X, B corresponds to Y, and C corresponds to Z, giving ABC ≅ XYZ. Options: 'ABC ≅ ZYX' puts Z in A's position, but A corresponds to X, not Z; 'ABC ≅ YXZ' puts Y in A's position, but A corresponds to X; 'ABC ≅ ZXY' puts Z in A's position and X in B's position, neither of which is correct. Answer: ABC ≅ XYZ.
- (b) A triangular prism standing on its triangular end — Method: a rectangular elevation with no sloping sides means the solid keeps the same cross-section all the way from the bottom to the top; work out which solid, standing the right way up, has a triangular cross-section that stays that shape as you go higher. Working: a triangular prism standing upright on its triangular end has a triangle as its plan view, and because the cross-section is constant all the way up, both the front and side elevations are plain rectangles. Answer: a triangular prism standing on its triangular end. The distractors: a triangle-based pyramid standing on its triangular base does give a triangle as its plan view, but its cross-section shrinks towards the apex, so its front and side elevations come to a point and are triangles, not rectangles. A cuboid standing on a rectangular face is wrong because its plan view is a rectangle, not a triangle. A triangular prism lying on one of its rectangular faces is wrong because it is then the triangular end that faces the side, so its plan view is a rectangle and one of its elevations is a triangle.
- (a) 6 cm — Method: a diameter runs right across a circle through its centre, so it is made of two radii laid end to end, which gives diameter = 2 × radius. Working: the radius is 3 cm, so the diameter is 2 × 3 = 6 cm. Answer: 6 cm. The distractors: 1.5 cm comes from dividing by 2 instead of multiplying by it, which is the relationship applied in the wrong direction; 3 cm comes from copying the radius straight down, treating the two words as names for the same measurement; 5 cm comes from adding 2 to the radius instead of multiplying the radius by 2.
Build your own mix at the worksheet builder.