Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) $\binom{4}{4}$ — A movement to the right is a positive top number and a movement up is a positive bottom number, so 4 right and 4 up gives $\binom{4}{4}$. $\binom{4}{-4}$ wrongly gives the vertical movement a negative sign, as if it were downward. $\binom{-4}{4}$ wrongly gives the horizontal movement a negative sign, as if it were leftward. $\binom{-4}{-4}$ gets both signs wrong, as if the translation were left and down.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (d) 10.3 m — By Pythagoras' theorem, the hypotenuse = √(5² + 9²) = √(25 + 81) = √106 = 10.29...≈ 10.3 m. "106 m" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "14 m" comes from adding the two shorter sides, 5 + 9, instead of using Pythagoras' theorem at all. "10.2 m" comes from rounding 10.29...m down to 10.2 instead of correctly rounding it up to 10.3.
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (d) Alternate angles are equal — The two 65° angles are on opposite sides of the line that crosses the parallel lines, in the shape of a Z, so they are alternate angles, and alternate angles between parallel lines are always equal. Corresponding angles are equal too, but they sit in matching positions at each crossing point, in the shape of an F — a different pair from the one shown here. Co-interior angles add up to 180°, not to each other's value, and they lie between the parallel lines on the same side, in the shape of a C. Angles on a straight line add up to 180°, but that rule is about two angles at a single point on one line, not about a pair of angles formed where a line crosses two parallel lines.
- (d) Yes, by the AA condition — Method: similarity is decided by the angles, and because the three angles of a triangle add up to 180°, two matching pairs force the third pair to match as well. Working: the angles at A and D are both 40° and the angles at B and E are both 70°, so the third angles are both 180° − 40° − 70° = 70° and all three pairs are equal. Two pairs were enough, and that is the AA condition. Answer: yes, by the AA condition. The distractors: 'Yes, by the SSS condition' names a condition about three pairs of sides in proportion, and the question gives no side lengths at all; 'No, because no side lengths are given' treats side information as necessary, which it is for congruence but not for similarity; 'No, because the triangles may be different sizes' turns the definition of similarity into an objection, since similar figures are allowed to differ in size and only their shape must match.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
- (b) 47 — Method: angles on a straight line add up to 180°. Working: 180 − 38 − 95 = 47. Answer: x = 47. A candidate who uses 360° instead of 180° gets 227. A candidate who subtracts only one of the two given angles from 180° gets 142. A candidate who adds the two given angles instead of subtracting them from 180° gets 133.
- (a) 8 — Method: two capacities can only be divided once they are written in the same unit. Working: there are 1000 ml in 1 litre, so the bottle holds 2 × 1000 = 2000 ml. Then 2000 ÷ 250 = 8. Answer: 8 glasses. Using 1 litre = 10 000 ml gives 20 000 ÷ 250 = 80. Dividing the two numbers as they stand, 250 ÷ 2 = 125, ignores the units altogether. Converting the glass into litres with the wrong factor, as though 250 ml were 2.5 litres, gives 2 ÷ 2.5 = 0.8.
- (c) 18 cm — Method: a square has four equal sides, so the perimeter is 4 × the side length. Working: 4 × 4.5 = 4 × 4 + 4 × 0.5 = 16 + 2 = 18. Answer: 18 cm. The distractors: 9 cm comes from 2 × 4.5, adding only one pair of sides; 16 cm comes from rounding the side length down to 4 cm before multiplying, so the 0.5 cm on each side is lost; 20.25 cm² comes from working out 4.5 × 4.5, which is the area of the tile and carries a squared unit.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
Build your own mix at the worksheet builder.