Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (a) 6 — A cuboid has six faces in total: a top, a bottom, a front, a back, and two ends — each one is a rectangle in the net, giving six rectangles altogether. Choosing 3 counts only the three PAIRS of congruent rectangles (top/bottom, front/back, two ends) rather than all six individual faces. Choosing 5 forgets one face, as if the net were missing its lid. Choosing 12 is the number of edges of a cuboid, not the number of rectangles in its net.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (c) 1 — Method: a right angle measures 90°, the three angles of any triangle add up to 180°, and a right-angled triangle is defined as a triangle that contains a right angle. Working: taking one right angle out of the total leaves 180° − 90° = 90° to be shared between the other two angles, so both of those must be acute; a second right angle would use the whole of that remaining 90° and leave nothing at all for the third angle, which is impossible. The definition therefore fixes the count at exactly one. Answer: 1. The distractors: 2 comes from counting the two sides that form the right angle instead of counting the angles themselves; 3 comes from reading the name as a description of the whole triangle, so that all three of its angles are taken to be right angles, which would need an angle sum of 3 × 90° = 270°; 0 comes from over-applying the angle sum — a candidate who works out that 90° + 90° = 180° leaves nothing for a third angle can conclude from that alone that no triangle may contain a right angle at all.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (a) (5, 2) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate, so (5, −2) maps to (5, 2). (−5, −2) changes the sign of the x-coordinate instead, which is what happens when reflecting in the y-axis. (−5, 2) changes the sign of both coordinates, which is the result of a rotation of 180° about the origin, not a reflection in the x-axis. (2, 5) comes from dropping the minus sign and then swapping the two numbers round, so neither coordinate has actually been reflected.
- (d) (−2, 0) — A 180° rotation about a centre (a, b) maps (x, y) to (2a − x, 2b − y). Here that gives (2 × 1 − 4, 2 × 1 − 2) = (−2, 0). A pupil who rotates about the origin instead of (1, 1) gets (−4, −2). A pupil who adds the centre's coordinates instead of applying the rotation formula gets (4 + 1, 2 + 1) = (5, 3). A pupil who just subtracts the centre's coordinates from E's, without doubling and reversing, gets (4 − 1, 2 − 1) = (3, 1). The correct image is (−2, 0).
- (b) 270° — Bearings are measured clockwise from north (000°). Due north is 000°, due east is 090°, due south is 180° and due west is 270°. Choosing 090° gives the bearing for due east, not west. Choosing 180° gives the bearing for due south. Choosing 000° gives the bearing for due north.
Build your own mix at the worksheet builder.