Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 25 cm² — Method: a square has four equal sides, so divide the perimeter by 4 to recover the side length, then square that side to get the area. Working: 20 ÷ 4 = 5 cm, then 5 × 5 = 25. Answer: 25 cm². The distractors: 400 cm² comes from squaring the perimeter itself, 20 × 20, treating the 20 cm as though it were the side length; 100 cm² comes from dividing the perimeter by 2 rather than by 4, giving a side of 10 cm, and squaring that; 5 cm is the side length, from stopping as soon as the perimeter has been divided by 4 and never squaring it, which also leaves a length where an area was asked for.
- (d) √3/2 — cos 30° is one of the exact values you must know: cos 30° = √3/2. The value 1/2 is the exact value of sin 30° (and of cos 60°), not cos 30°. The value √2/2 is the exact value of cos 45° (and of sin 45°). The value 1 is the exact value of cos 0°.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (c) RHS applies: the right angle, hypotenuse and one matching side are all equal — Both triangles are right-angled, and the hypotenuses (AC and DF) are equal, and one further pair of matching sides (AB and DE) are equal. This matches the Right angle-Hypotenuse-Side condition, which needs only these three facts, not a third side.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (d) 42.4 cm² — Sector area = (angle ÷ 360) × π × r². First, 60 ÷ 360 = 1/6. Next, π × r² = 3.14 × 81 = 254.34 cm². So the area = (1/6) × 254.34 = 42.39 cm², which rounds to 42.4 cm². (4.7 cm² comes from forgetting to square the radius: using π × r = 3.14 × 9 = 28.26, then (1/6) × 28.26 = 4.71 cm²; 254.3 cm² comes from finding the area of the whole circle, 254.34 cm², and forgetting the angle fraction; 9.4 cm² comes from using the arc length formula instead: 2 × π × r = 2 × 3.14 × 9 = 56.52 cm, then (1/6) × 56.52 = 9.42 cm.)
- (d) (6, 8) — Method: add column vectors by adding the top numbers together and the bottom numbers together. Working: top numbers 5 + 1 = 6; bottom numbers 2 + 6 = 8. Answer: p + q = (6, 8). A candidate who subtracts instead of adds gets (4, −4). A candidate who swaps the top and bottom of the correct answer gets (8, 6). A candidate who only adds the top numbers and leaves the bottom number of p unchanged gets (6, 2).
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (d) ASA - two angles and the included side equal — Two angles (A and B) are given, and AB is the side between them, so this is ASA. SAS needs two sides and the angle between them, but only one side is given. AAS also uses two angles and a side, but the side must NOT be between the two angles — here AB is between angle A and angle B, so it is ASA, not AAS. RHS needs a right angle, and neither 40° nor 65° is 90°.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (c) 18 — Rearranging F + V − E = 2 gives E = F + V − 2. Substitute F = 8 and V = 12: 8 + 12 − 2 = 18 edges. Choosing 20 comes from adding the faces and vertices but forgetting to subtract the 2 (8 + 12 = 20). Choosing 22 comes from adding the 2 instead of subtracting it (8 + 12 + 2 = 22). Choosing 16 comes from subtracting 2 twice by mistake (8 + 12 − 2 − 2 = 16).
- (b) 4 — The scale factor is the distance from the centre to the image, divided by the distance from the centre to the object: (5 − 1) ÷ (2 − 1) = 4 ÷ 1 = 4. (2.5 comes from dividing the raw y-coordinates, 5 ÷ 2, without first subtracting the centre's coordinate; 3 comes from subtracting the two distances instead of dividing them; 0.25 comes from dividing the distances the wrong way round.)
Build your own mix at the worksheet builder.