Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Square — A square has all four sides equal, all four angles equal to 90°, and diagonals that are equal in length and bisect each other at right angles — every part of the description matches, so Square is correct. A rhombus has all four sides equal and diagonals bisecting at right angles, but its interior angles are not generally 90° (only a square, a special rhombus, has that), so it does not fully match. A rectangle has four 90° angles and equal diagonals, but its sides are not all equal in general, so it fails the equal-sides condition. A kite has two pairs of adjacent equal sides rather than all four sides equal, and its diagonals are not generally equal in length, so it fails both conditions.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (c) 24 cm² — Method: the front elevation of a cuboid is a rectangle formed by the cuboid's length and its height, so its area is length × height. Working: 6 cm × 4 cm = 24 cm². Answer: 24 cm². The distractors: 12 cm² comes from using width × height (3 × 4) instead of length × height, mistaking the side elevation's dimensions for the front's. 18 cm² comes from using length × width (6 × 3), which gives the area of the plan view instead of the front elevation. 20 cm² comes from finding the perimeter of the front face instead of its area: 2 × (6 + 4) = 20.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (d) SSS — All three pairs of corresponding sides are equal (PQ = ST, QR = TU, PR = SU), so the triangles are congruent by the SSS (side-side-side) condition. The distractor SAS would apply if two sides and the included angle were given equal, not three sides. The distractor ASA would apply if two angles and the included side were given equal. The distractor RHS would apply only for right-angled triangles with the hypotenuse and one other side equal.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (c) 21 cm — Method: the perimeter is the distance all the way round the edge, so every side is counted once and the three side lengths are added. Working: the two equal sides give 8 + 8 = 16 cm, and the third side adds 5 cm to that. Answer: the perimeter is 21 cm. The distractors: 16 cm comes from adding the two 8 cm sides and handing that total in before the third side has been included; 13 cm comes from adding one 8 cm side to the 5 cm side, as though the badge carried only the two different lengths printed on it rather than three sides; 24 cm comes from taking all three sides to be 8 cm and working out 3 × 8, which would be the perimeter only if the badge were equilateral.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (b) (3, −3) — Subtracting column vectors means subtracting the top numbers and subtracting the bottom numbers, in the order given: top = 5 − 2 = 3, bottom = 1 − 4 = −3, giving (3, −3). A candidate who works out v − u instead of u − v, reversing the order, gets (−3, 3). A candidate who makes a sign error on the bottom number, treating 1 − 4 as 3 instead of −3, gets (3, 3). A candidate who adds the vectors instead of subtracting gets (7, 5). Because the question asks for u − v, not v − u, the correct answer is (3, −3).
- (b) 3 — Method: the scale factor is a length of the second triangle divided by the corresponding length of the first, and corresponding means shortest paired with shortest. Working: the shortest side of the first triangle is 3 cm and the shortest side of the second is 9 cm, so the scale factor is 9 ÷ 3 = 3. Answer: 3. The distractors: 1/3 comes from dividing 3 by 9, which is the scale factor from the second triangle back to the first; 6 comes from subtracting, 9 − 3, treating the scale factor as a difference rather than a multiplier; 1.8 comes from dividing 9 by 5, pairing the second triangle's shortest side with the first triangle's longest side.
- (b) (12, −8) — Method: to multiply a column vector by a number, multiply every part of the vector by that number. Working: top number 4 × 3 = 12; bottom number 4 × (−2) = −8. Answer: 4a = (12, −8). A candidate who adds 4 to each part instead of multiplying gets (7, 2). A candidate who multiplies only the top number by 4 and leaves the bottom number unchanged gets (12, −2). A candidate who multiplies only the bottom number by 4 and leaves the top number unchanged gets (3, −8).
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
Build your own mix at the worksheet builder.