Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) They are always equal to each other — Method: label the four angles a, b, c, d in order around the crossing point, then use the fact that neighbouring angles lie on a straight line. Working: a and b lie on a straight line, so a + b = 180°; b and c also lie on a straight line, so b + c = 180°. Both a and c are therefore 180° minus b, which forces a = c. Answer: a pair of vertically opposite angles is always equal to each other. The distractors: the claim that each is 90° holds only when the two lines happen to be perpendicular, so it is not always true; the claim that they add to 180° confuses the opposite pair with the neighbouring pair that lies along a straight line, and again holds only in the perpendicular case; the claim that they add to 360° uses the total of all four angles at the point rather than of the opposite pair.
- (d) SSS — All three pairs of corresponding sides are equal (PQ = ST, QR = TU, PR = SU), so the triangles are congruent by the SSS (side-side-side) condition. The distractor SAS would apply if two sides and the included angle were given equal, not three sides. The distractor ASA would apply if two angles and the included side were given equal. The distractor RHS would apply only for right-angled triangles with the hypotenuse and one other side equal.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (d) (6, 8) — Method: add column vectors by adding the top numbers together and the bottom numbers together. Working: top numbers 5 + 1 = 6; bottom numbers 2 + 6 = 8. Answer: p + q = (6, 8). A candidate who subtracts instead of adds gets (4, −4). A candidate who swaps the top and bottom of the correct answer gets (8, 6). A candidate who only adds the top numbers and leaves the bottom number of p unchanged gets (6, 2).
- (b) 60 cm² — Method: the area of a triangle is half the base multiplied by the perpendicular height, and here the perpendicular height is the 12 cm, not the sloping side. Working: 10 × 12 = 120, then 120 ÷ 2 = 60. Answer: 60 cm². The distractors: 65 cm² comes from using the sloping side of 13 cm as the height, (10 × 13) ÷ 2; 120 cm² comes from using the right two lengths but forgetting to halve, 10 × 12; 78 cm² comes from taking 13 cm and 12 cm as the base and the height and ignoring BC altogether, (13 × 12) ÷ 2.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (c) 34 cm — Method: a rectangle has two lengths and two widths, so the perimeter is 2 × (length + width). Working: 12 + 5 = 17, then 2 × 17 = 34. Answer: 34 cm. The distractors: 17 cm comes from adding one length and one width and stopping, which is only half of the way round; 24 cm comes from doubling the length alone, 2 × 12, and leaving the two widths out; 60 cm² comes from working out 12 × 5, which is the area of the photograph and carries a squared unit because two lengths have been multiplied.
- (a) a cone — A cone, viewed from directly above, shows its circular base as a circle; viewed from the front, its curved surface narrows to a point at the apex, giving a triangle outline — so a circle plan with a triangle elevation identifies a cone. "a cylinder" has a circular plan too, but its front elevation is a rectangle, not a triangle, since its sides run straight up rather than narrowing to a point. "a sphere" gives a circle from every direction, plan and every elevation alike, not a triangle from the front. "a square-based pyramid" gives a triangle from the front, but its plan view is a square, not a circle.
- (a) 3 cm² — Area scale factor = (linear scale factor)² = (1/4)² = 1/16. Area of T = 48 × 1/16 = 3 cm². (12 cm² comes from multiplying by the linear scale factor 1/4 directly, without squaring it; 24 cm² comes from taking the square root of the scale factor instead of squaring it; 768 cm² comes from squaring the reciprocal of the scale factor, 4, instead of the scale factor itself.)
- (d) 1250 g — There are 1000 g in a kilogram, so 1.25 kg = 1.25 × 1000 = 1250 g. Multiplying by 100 instead of 1000 gives 125 g. Converting only the whole 1 kg and forgetting the extra 0.25 kg gives 1000 g. Treating the 0.25 kg as 25 g instead of 250 g, a quarter of 1000, gives 1025 g.
- (c) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides.
Build your own mix at the worksheet builder.