Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) an arc of the same radius, centred at B — The perpendicular bisector construction needs two arcs of equal radius, one centred at each end of the segment — after the arc from A, the next step is an arc of exactly the same radius from B, so the two arcs cross at two points; the line through those two crossing points is the perpendicular bisector. "an arc of the same radius, centred at the midpoint of AB" is not possible yet, since the midpoint is only found once both arcs are drawn — it is the RESULT of the construction, not a step in it. "a smaller arc, centred at A again" gives two different-sized arcs from the same point, which never cross to give the bisector. "a straight line joining the ends of the first arc" only connects points on one arc, and locates nothing.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (d) Alternate angles are equal — The two 65° angles are on opposite sides of the line that crosses the parallel lines, in the shape of a Z, so they are alternate angles, and alternate angles between parallel lines are always equal. Corresponding angles are equal too, but they sit in matching positions at each crossing point, in the shape of an F — a different pair from the one shown here. Co-interior angles add up to 180°, not to each other's value, and they lie between the parallel lines on the same side, in the shape of a C. Angles on a straight line add up to 180°, but that rule is about two angles at a single point on one line, not about a pair of angles formed where a line crosses two parallel lines.
- (b) 25 cm² — Method: a square has four equal sides, so divide the perimeter by 4 to recover the side length, then square that side to get the area. Working: 20 ÷ 4 = 5 cm, then 5 × 5 = 25. Answer: 25 cm². The distractors: 400 cm² comes from squaring the perimeter itself, 20 × 20, treating the 20 cm as though it were the side length; 100 cm² comes from dividing the perimeter by 2 rather than by 4, giving a side of 10 cm, and squaring that; 5 cm is the side length, from stopping as soon as the perimeter has been divided by 4 and never squaring it, which also leaves a length where an area was asked for.
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (a) (−2, 6) — Translating by the vector (−5, 4) means adding −5 to the x-coordinate and adding 4 to the y-coordinate: (3 + (−5), 2 + 4) = (−2, 6). (8, 6) comes from treating −5 as +5, adding instead of subtracting on the x-coordinate. (−2, −2) keeps the x-coordinate correct but subtracts 4 from the y-coordinate instead of adding it. (7, −3) comes from swapping the two components of the vector, applying 4 to the x-coordinate and −5 to the y-coordinate.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
Build your own mix at the worksheet builder.