Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
- (b) 16.747 m³ — Volume of a sphere = (4/3)πr³, so a hemisphere is half that: (2/3)πr³. Substitute r = 2: (2/3) × 3.14 × 2³ = (2/3) × 3.14 × 8 = (2/3) × 25.12 = 16.7467 m³, which rounds to 16.747 m³.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (a) 7 — Rearranging F + V − E = 2 gives F = 2 − V + E = 2 − 10 + 15 = 7. A candidate who works out E − V without the +2, giving 15 − 10, answers 5. A candidate who rearranges with a sign error, working out 2 + V − E = 2 + 10 − 15 = −3 and then drops the negative sign, answers 3. A candidate who adds all three numbers together, V + E + 2 = 10 + 15 + 2, answers 27, having used the wrong operation entirely. The correct number of faces is 7.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
Build your own mix at the worksheet builder.