Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
- (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (c) 32 cm — Method: a perimeter is lengths added together, so it scales by the length scale factor itself, which is 4 ÷ 3 going from the smaller triangle to the larger one — not by its square. Working: 24 ÷ 3 = 8, and 8 × 4 = 32. Answer: 32 cm. The distractors: 18 cm comes from multiplying by 3 ÷ 4, scaling from the larger triangle down to the smaller one; 25 cm comes from adding the difference between the parts of the ratio, 4 − 3 = 1, to the perimeter; 8 cm comes from dividing by 3 and stopping there, before multiplying by 4.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
- (c) 34 cm — Method: a rectangle has two lengths and two widths, so the perimeter is 2 × (length + width). Working: 12 + 5 = 17, then 2 × 17 = 34. Answer: 34 cm. The distractors: 17 cm comes from adding one length and one width and stopping, which is only half of the way round; 24 cm comes from doubling the length alone, 2 × 12, and leaving the two widths out; 60 cm² comes from working out 12 × 5, which is the area of the photograph and carries a squared unit because two lengths have been multiplied.
- (b) Right angle, equal hypotenuse, one more side — RHS requires a right angle in each triangle, equal hypotenuses, and one further pair of equal sides, so 'right angle, equal hypotenuse, one more side' is correct. 'Right angle, hypotenuse, one more angle' is wrong because it asks for an extra equal angle instead of an extra equal side, which RHS does not check. 'Two sides and the angle between them' describes SAS, not RHS, so it is wrong. 'Right angle and all three sides equal' describes SSS with an extra right-angle condition, asking for more information than RHS actually needs, so it is wrong.
- (c) 1.44 m³ — The cross-section is a triangle, so its area = base × height ÷ 2. Base × height = 1.2 × 0.8 = 0.96 m², and half of that is 0.96 ÷ 2 = 0.48 m². The volume of the prism = cross-sectional area × length = 0.48 × 3 = 1.44 m³. A pupil who forgets to halve when finding the triangle's area gets 1.2 × 0.8 × 3 = 2.88 m³. A pupil who ignores the height altogether, treating the cross-section as base × length, gets 1.2 × 3 = 3.6 m³. A pupil who correctly finds the cross-sectional area but forgets to multiply by the length of the bed stops at 0.48 m³. The correct volume of soil is 1.44 m³.
- (a) (−2, 6) — Translating by the vector (−5, 4) means adding −5 to the x-coordinate and adding 4 to the y-coordinate: (3 + (−5), 2 + 4) = (−2, 6). (8, 6) comes from treating −5 as +5, adding instead of subtracting on the x-coordinate. (−2, −2) keeps the x-coordinate correct but subtracts 4 from the y-coordinate instead of adding it. (7, −3) comes from swapping the two components of the vector, applying 4 to the x-coordinate and −5 to the y-coordinate.
- (d) $\binom{0}{4}$ — Add the three vectors component by component: x: 3 + (−7) + 4 = 0; y: −2 + 5 + 1 = 4, giving $\binom{0}{4}$. $\binom{−4}{3}$ comes from adding only the first two vectors and forgetting the third. $\binom{14}{−6}$ comes from reading the second vector as $\binom{7}{−5}$ instead of $\binom{−7}{5}$, flipping its signs. $\binom{4}{0}$ comes from swapping the final x-total and y-total.
Build your own mix at the worksheet builder.