Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 50° — Method: the three angles of a triangle add up to 180°, and the two angles opposite the equal sides are equal, so subtract the given angle from 180° and halve the remainder. Working: 180° − 80° = 100°, and 100° ÷ 2 = 50°. Answer: 50°. The distractors: 100° comes from subtracting from 180° and forgetting to halve, so it is the two equal angles together; 40° comes from halving the 80° that is given rather than halving what is left of the 180°; 80° comes from assuming that the two base angles must match the angle between the equal sides.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
- (a) Infinitely many — Method: a radius is any straight line from the centre of a circle to a point on the circle, so counting the radii means counting the possible end points, and those end points are the points of the circle itself. Working: a circle is a continuous curve, so between any two points on it there is always another point; the supply of end points therefore never runs out, and each end point gives one radius. Every one of those radii is the same length, because equal distance from the centre is what makes the curve a circle in the first place. Answer: Infinitely many. The distractors: Exactly one comes from treating a radius as a single fixed line, because a textbook diagram usually shows only one drawn in; Exactly two comes from picturing a diameter and counting the two halves it is made of; Exactly four comes from picturing the circle cut into quarters by two perpendicular diameters and counting the four radii that appear in that picture.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (d) 56.5 cm — Circumference = 2πr. With r = 9 cm and π = 3.14, circumference = 2 × 3.14 × 9 = 56.52 cm, which rounds to 56.5 cm. A student who uses πr instead of 2πr, forgetting to double, gets 3.14 × 9 = 28.26 cm, rounding to 28.3 cm. A student who uses the area formula πr² instead of the circumference formula gets 3.14 × 81 = 254.34 cm², rounding to 254.3. A student who doubles the correct circumference by mistake gets 56.52 × 2 = 113.04 cm, rounding to 113.0 cm.
- (a) 5/12 — A sector's area is always the same fraction of the circle as its angle is of the full 360° turn. Here that fraction is 150 out of 360, which simplifies (divide both numbers by 30) to 5/12. Treating a full turn as 180° instead of 360° gives 5/6. Confusing the 150° given with the 180° of a half turn gives 1/2. Working out the fraction OUTSIDE the sector instead of inside it gives 7/12.
- (b) £1.57 — Slice area = (90 ÷ 360) × 3.14 × 10² = 0.25 × 314 = 78.5 cm². Cost = 78.5 × £0.02 = £1.57. (£0.16 comes from forgetting to square the radius, using 0.25 × 3.14 × 10 for the area; £6.28 comes from finding the area of the whole cake and forgetting the angle fraction; £0.31 comes from using the arc length formula instead of the sector area formula.)
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (d) 60° — Method: the 4 cm side is next to the angle wanted and the 8 cm side is the hypotenuse, so the ratio built from them is cos θ = adjacent ÷ hypotenuse, and the angle comes from the inverse cosine. Working: cos θ = 4 ÷ 8 = 0.5, so θ = cos⁻¹(0.5). Answer: 60°. The distractors: 30° comes from using sin⁻¹(0.5), which treats the 4 cm side as the side opposite the angle when it is the side next to it; 45° comes from assuming the two acute angles of the triangle must be equal; 90° comes from writing down the right angle the question already gives instead of the angle it asks for.
- (d) Equilateral — Method: triangles are named by their sides — three equal sides, exactly two equal sides, or no equal sides — or by their angles. Working: the triangle described has three equal sides, which is the equilateral case, and each of its angles is 60°. Answer: equilateral. The distractors: isosceles is the name for a triangle with exactly two equal sides, and is chosen by candidates who remember only that it is the 'equal sides' word; scalene is the name for a triangle whose sides are all different, so it is the opposite of what is described; right-angled classifies a triangle by an angle of 90° rather than by its sides, and is chosen by candidates who recall that the angles of this triangle are all equal and take 'equal angles' to mean 'right angles'.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (b) trapezium — A quadrilateral with exactly one pair of parallel sides is a trapezium; field ABCD has AB parallel to DC and no other pair of parallel sides, so trapezium is correct. Parallelogram requires BOTH pairs of opposite sides to be parallel, but the plan says only AB and DC are parallel. Rhombus requires all four sides to be equal in length, which is not stated here. A kite is defined by two pairs of adjacent equal sides, not by having a pair of parallel sides, so it does not match this description either.
- (a) 9 — A triangular prism has two triangular ends and three rectangular side faces. Each triangular end contributes 3 edges, giving 6 edges for both ends, and three more edges run lengthways to join the two ends together: 6 + 3 = 9 edges. Choosing 6 counts only the vertices (3 on each triangular end). Choosing 5 counts the faces (2 triangular + 3 rectangular) instead of the edges. Choosing 12 is the edge count of a cuboid, not a triangular prism.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
Build your own mix at the worksheet builder.