Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
- (c) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides.
- (c) 12 cm — By Pythagoras' Theorem, QR² = PQ² + PR², so PR² = QR² − PQ² = 15² − 9² = 225 − 81 = 144. Square root: √144 = 12 cm.
- (b) √2/2 — sin 45° = √2/2 (the same value as 1/√2, written with a rational denominator) — one of the exact values you need to know. √3/2 is the exact value of sin 60° and of cos 30°, not sin 45°. 1/2 is the exact value of sin 30° and of cos 60°. 1 is the exact value of sin 90°.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (b) 16.747 m³ — Volume of a sphere = (4/3)πr³, so a hemisphere is half that: (2/3)πr³. Substitute r = 2: (2/3) × 3.14 × 2³ = (2/3) × 3.14 × 8 = (2/3) × 25.12 = 16.7467 m³, which rounds to 16.747 m³.
- (a) Infinitely many — Method: a radius is any straight line from the centre of a circle to a point on the circle, so counting the radii means counting the possible end points, and those end points are the points of the circle itself. Working: a circle is a continuous curve, so between any two points on it there is always another point; the supply of end points therefore never runs out, and each end point gives one radius. Every one of those radii is the same length, because equal distance from the centre is what makes the curve a circle in the first place. Answer: Infinitely many. The distractors: Exactly one comes from treating a radius as a single fixed line, because a textbook diagram usually shows only one drawn in; Exactly two comes from picturing a diameter and counting the two halves it is made of; Exactly four comes from picturing the circle cut into quarters by two perpendicular diameters and counting the four radii that appear in that picture.
- (d) 600 cm² — Enlarging by scale factor 2 makes the new dimensions 10 × 2 = 20 cm and 15 × 2 = 30 cm, so the poster's area = 20 × 30 = 600 cm². A pupil who scales the original area, 150 cm², by the scale factor itself instead of by its square gets 150 × 2 = 300 cm². A pupil who adds the scale factor to each dimension instead of multiplying gets (10 + 2) × (15 + 2) = 204 cm². A pupil who forgets to enlarge the postcard at all just uses the original area, 150 cm². The correct area of the poster is 600 cm².
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (c) 150 minutes — There are 60 minutes in an hour, so 2.5 hours is 2.5 × 60 = 150 minutes. Multiplying by 100 instead of 60, as if hours worked like a decimal metric unit, gives 250 minutes. Converting only the whole 2 hours and forgetting the extra 0.5 hours gives 120 minutes. Treating the 0.5 as 50 minutes, out of 100, instead of 30 minutes, out of 60, gives 170 minutes.
Build your own mix at the worksheet builder.