Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A ladder of length 7 m leans against a vertical wall. The foot of the ladder is 3 m from the base of the wall. Work out how high up the wall the ladder reaches. Give your answer correct to 1 decimal place.
- 2.A cake recipe takes 135 minutes from start to finish. Write this time as hours and minutes.
- 3.A solid cone has a base radius of 6 cm and a vertical height of 10 cm. Work out the volume of the cone. Use π = 3.14 and give your answer correct to 1 decimal place.
- 4.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 5.A sector of a circle has radius 6 cm and an arc length of 15.7 cm. Using π = 3.14, work out the angle of the sector.
- 6.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 7.A triangular flag has a base of 40 cm and a perpendicular height of 25 cm. Work out its area.
- 8.A fish tank is a cuboid measuring 40 cm long, 25 cm wide and 30 cm high. Water is poured in to a depth of 20 cm. Work out the volume of water in the tank, in litres.
- 9.A solid rubber ball has a radius of 3 cm. Work out the volume of the ball. Use π = 3.14.
- 10.A water tank is a cube with edges of length 2 m. Work out how many cubic centimetres the tank holds when it is full.
- 11.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 12.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 13.A circular coaster has a radius of 4 cm. Work out the circumference of the coaster. Give your answer in terms of π.
- 14.A circular clock face has a radius of 9 cm. Work out the circumference of the clock face. Use π = 3.14. Give your answer to 1 decimal place.
- 15.A hiker starts by walking on a bearing of 245°. She turns clockwise through 50°, then turns clockwise through a further 15°, and continues walking in a straight line. What bearing is she now walking on?
Build your own mix at the worksheet builder.