Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A solid cone has a base radius of 6 cm and a vertical height of 10 cm. Work out the volume of the cone. Use π = 3.14 and give your answer correct to 1 decimal place.
- 2.In a right-angled triangle one of the other two angles is 45°, and the side opposite that 45° angle is 7 cm. Work out the length of the hypotenuse. Give your answer to 1 decimal place.
- 3.Three angles meet at a single point on one side of a straight line. Two of the angles are 48° and 65°. Work out the third angle.
- 4.A vertical line passes through the point (5, 2). Write down the equation of this line.
- 5.A composite solid is made from a cylinder of radius 3 cm and height 10 cm, with a cone of the same radius and vertical height 4 cm fixed on top, apex upward. Work out the total volume of the solid. Use π = 3.14 and give your answer correct to 1 decimal place.
- 6.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder.
- 7.Two similar signs have lengths in the ratio 9 : 4. The larger sign has a side of length 14.4 cm. Work out the length of the corresponding side of the smaller sign.
- 8.Sam says: '3.2 litres is the same as 320 ml, because you multiply by 100.' Which statement about Sam's claim is correct?
- 9.A bus journey takes 2.5 hours. Work out how many minutes this is.
- 10.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 11.A model of a bridge is built to a scale where every length on the model is 1/240 of the matching length on the real bridge. A support beam on the model measures 3.6 cm. Work out the length of the real support beam, giving your answer in metres.
- 12.A scale drawing uses a scale of 1 : 60. A path on the drawing is measured as 9.8 cm long. What is the real length of the path, in metres, to 1 decimal place?
- 13.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 14.Two vertical masts stand on level ground, 40 m apart. One mast is 30 m tall and the other is 50 m tall. Work out the straight-line distance between the tops of the two masts. Give your answer to 1 decimal place.
- 15.In a right-angled triangle, θ is one of the acute angles. Write down the trigonometric ratio, in terms of the opposite and adjacent sides, that is used to find θ.
Build your own mix at the worksheet builder.