Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A shop stacks tins in a display block. The front elevation of the block is 4 tins wide and 3 tins high. The side elevation shows the block is 2 tins deep. Every position in the block is filled. How many tins are used in total?
- 2.A solid is built from centimetre cubes standing on a table. Seen from the front, the left-hand column is 2 cubes high, the middle column is 2 cubes high and the right-hand column is 1 cube high. Work out how many squares make up the front elevation.
- 3.Write down the exact value of tan 0°.
- 4.A builder props a straight plank against a vertical wall to reach a window ledge. The foot of the plank is 2.1 m from the base of the wall, and the plank is 3.5 m long. Work out how high up the wall the plank reaches.
- 5.A cylindrical tin has a curved surface, a flat circular base and a flat circular lid. A label is stuck around the curved surface only. How many of the tin's faces are NOT covered by the label?
- 6.A student draws a net using 5 identical squares arranged in a row of four with one extra square attached to the side of one of them. Can this net be folded to make a closed cube?
- 7.A perpendicular bisector is drawn through the midpoint of a line segment AB. Which set of points does this construction show?
- 8.A roof has two triangular sections, P and Q. Section P has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them. Section Q has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them, arranged the same way round. A roofer wants to cut identical triangular felt panels for both sections without measuring Section Q separately. Which condition confirms that the two sections are congruent?
- 9.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?
- 10.a is the column vector with top number 3 and bottom number −2. Work out 4a, giving your answer as a column vector in the form (top, bottom).
- 11.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 12.A tile manufacturer cuts a hexagonal tile so that all six sides measure exactly 4 cm, but a check shows only two pairs of the six interior angles are equal to each other, not all six angles. The customer's order specifies regular hexagonal tiles. Based on the check, is this tile a regular hexagon?
- 13.The interior angles of a pentagon are 100°, 110°, 120°, x° and x°. Work out the size of each of the two angles marked x°.
- 14.At a point on a straight line, two angles are formed. One of them is 63°. Work out the size of the other angle.
- 15.Point A is at (2, 3). It is translated by the vector (4, −1) to give point A′. Work out the coordinates of A′.
Build your own mix at the worksheet builder.