Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A locus is described as the set of points exactly 4 cm from a fixed point O. What shape is this locus?
- 2.In geometry, which of the following best describes a 'plane'?
- 3.A solid has one curved surface and two flat circular faces of equal size, one at each end. What is the name of this solid?
- 4.A square has sides of length 7 cm. Work out its area.
- 5.Two angles are supplementary. One of them is twice the size of the other. Work out the size of the smaller angle.
- 6.A cylinder has a radius of 5 cm. Its volume is 471 cm³. Using π = 3.14, work out the height of the cylinder.
- 7.After a translation by the vector , a point lands on (4, 1). Write down the coordinates of the point before the translation.
- 8.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 9.Write down the name given to a quadrilateral with exactly one pair of parallel sides.
- 10.Point C is at (2, 3). It is rotated 90° clockwise about the origin. Work out the coordinates of the image of point C.
- 11.A cylindrical tin has a curved surface, a flat circular base and a flat circular lid. A label is stuck around the curved surface only. How many of the tin's faces are NOT covered by the label?
- 12.Three angles meet at a single point on one side of a straight line. Two of the angles are 48° and 65°. Work out the third angle.
- 13.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?
- 14.A regular polygon has an exterior angle of 45°. Work out the number of sides of the polygon.
- 15.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
Build your own mix at the worksheet builder.