Printable · GCSE Foundation · ages 14-16
Ordering numbers and inequality symbols worksheet — GCSE Foundation
Fifteen questions on "ordering numbers and inequality symbols" — DfE statement N1. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Non-calculator
Answer key: Ordering numbers and inequality symbols worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) −2 — Method: place the two end values on a number line and list the integers that sit strictly between them. Working: reading from left to right the integers run −4, −3, −2, −1, so the values strictly between the ends are −3 and −2. Only one of those is offered. Answer: −2. The distractors: −5 comes from ordering negatives by the size of their digits, which wrongly places −5 to the right of −4; 0 comes from carrying on past −1 instead of stopping at it; 2 comes from ignoring the minus signs and choosing a number between 1 and 4.
- (d) the first mark after 0 — Method: when a unit length is split into equal parts, each gap is one part of the whole, so 1/4 is one gap along from 0. Working: four equal parts means each gap measures 1/4, so the marks after 0 stand for 1/4, 2/4, 3/4 and 4/4. One gap along from 0 is therefore the mark for 1/4. Answer: the first mark after 0. The distractors: the second mark after 0 comes from counting 0 itself as the first mark; the third mark after 0 comes from counting back from the 1 end instead of forward from 0; the fourth mark after 0 comes from reading the 4 in the denominator as the number of the mark rather than the number of parts.
- (d) −8, −3, 0, 2, 5 — Method: place the numbers on a number line and read them from left to right. Working: the negative numbers −8 and −3 come before 0, with −8 further left than −3 because it is further from zero in the negative direction; then 0, then the positive numbers 2 and 5 in increasing size. Answer: −8, −3, 0, 2, 5. −3, −8, 0, 2, 5 swaps −3 and −8, putting the negative number closer to zero first. 5, 2, 0, −3, −8 lists the numbers from largest to smallest instead of smallest to largest. −8, −3, 2, 0, 5 puts 2 before 0, treating positive numbers as if they always come before zero.
- (c) < — Method: compare the two negative numbers by their position on a number line, not by the size of the digit. Working: −9 is nine places to the left of zero and −4 is four places to the left of zero, so −9 is further from zero in the negative direction, which makes it the smaller number. Answer: −9 < −4, so the symbol is <. > comes from comparing 9 and 4 as if both numbers were positive, ignoring the negative signs. = comes from treating both numbers as equal simply because they are both negative. ≥ combines > (false) with = (also false).
- (d) −6 — Method: check each option to see if it falls strictly between −8 and −5, remembering that numbers become smaller as they get more negative. Working: −8 < −6 < −5, so −6 lies between them. Answer: −6. −9 comes from a value that is more negative than −8, so it lies outside the range, below −8. −4 comes from a value that is less negative than −5, so it lies outside the range, above −5. 6 comes from ignoring the negative signs and picking a positive number between 5 and 8.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (a) = — Method: convert the fraction to a decimal so both numbers are in the same form. Working: 3/10 means 3 divided by 10, which is 0.3. Answer: 3/10 = 0.3, so the symbol is =. < comes from treating the fraction as smaller than the decimal without converting it first. > comes from the same mistake the other way round. ≠ comes from assuming a fraction and a decimal can never be equal.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (c) 6/8 — Method: two fractions can only be compared directly when they share a denominator, so rewrite 3/4 in eighths and then compare the numerators. Working: 5/8 is already in eighths, and 3/4 = (3 × 2)/(4 × 2) = 6/8. Comparing the numerators, 6 > 5, so Oliver eats the larger share. Answer: 6/8. The distractors: 5/8 comes from skipping the conversion altogether and assuming that a bar cut into eighths must give the bigger share because it has more pieces; once both shares are written over the same denominator, 5 eighths is one eighth less than 6 eighths. 1/8 comes from working out how much more Oliver eats, 6/8 − 5/8, instead of writing down the greater of the two shares. 7/8 comes from adding 4 to the numerator and 4 to the denominator of 3/4 instead of multiplying both by 2.
- (c) < — Compare the two decimals by their value, not by how many digits they have: 0.45 is worth less than half, while 0.5 is exactly half, so 0.45 is smaller. The correct symbol is <, since 0.45 is less than 0.5. Choosing > treats 0.45 as bigger because it has more digits after the decimal point than 0.5 — extra decimal digits do not make a number bigger. Choosing = comes from rounding 0.45 to 1 decimal place, 0.5, and then treating the rounded value as if it were the original number. Choosing ≥ would mean 0.45 is greater than or equal to 0.5, which is false in both parts, since 0.45 is neither equal to nor bigger than 0.5. So 0.45 < 0.5.
- (b) −0.7 < −0.25 — Method: compare the two negative decimals by their distance from zero on a number line. Working: −0.7 is 0.7 away from zero and −0.25 is 0.25 away from zero, so −0.7 is further from zero in the negative direction, making it the smaller number. Answer: −0.7 < −0.25 is true. "−0.7 > −0.25" comes from comparing 0.7 and 0.25 as if both numbers were positive, ignoring the negative signs. "−0.7 = −0.25" comes from assuming the two numbers are equal because they are both negative decimals. "−0.7 ≥ −0.25" combines the false statement "−0.7 > −0.25" with the false statement "−0.7 = −0.25".
- (a) 7/8, 17/20, 0.8, 78% — Method: convert every value to a decimal, then order the decimals from largest to smallest. Working: 7/8 = 0.875, 17/20 = 0.85, 0.8 = 0.8, 78% = 0.78. Ordering from largest to smallest gives 7/8, 17/20, 0.8, 78%. Answer: 7/8, 17/20, 0.8, 78%. '78%, 0.8, 17/20, 7/8' comes from ordering the converted decimals from smallest to largest instead of largest to smallest. '17/20, 7/8, 0.8, 78%' comes from converting 17/20 incorrectly as larger than 7/8, for example treating 17/20 as 0.87 instead of 0.85, swapping the top two. '7/8, 0.8, 17/20, 78%' comes from converting 17/20 incorrectly as equal to 0.8, swapping the middle two.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (c) 0.5, 0.45, −0.09, −0.15, −0.6 — Method: compare the decimals by their position on a number line, remembering that with negative decimals the one closer to zero is larger. Working: 0.5 and 0.45 are positive, so they come first, with 0.5 the larger of the two. Among the negatives, −0.09 is closest to zero, then −0.15, then −0.6 is furthest from zero and so the smallest. Answer: 0.5, 0.45, −0.09, −0.15, −0.6. 0.5, 0.45, −0.15, −0.09, −0.6 swaps −0.09 and −0.15, treating the negative decimal with more digits after the point as closer to zero. −0.6, −0.15, −0.09, 0.45, 0.5 lists the numbers from smallest to largest instead of largest to smallest. 0.5, 0.45, −0.6, −0.15, −0.09 orders the negative decimals by the size of the digit (0.6 > 0.15 > 0.09) as if they were positive, instead of recognising that a bigger negative decimal is further from zero and so smaller.
Build your own mix at the worksheet builder.