Printable · GCSE Foundation · ages 14-16
Ordering numbers and inequality symbols worksheet — GCSE Foundation
Fifteen questions on "ordering numbers and inequality symbols" — DfE statement N1. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Ordering numbers and inequality symbols worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (d) −5, −1, 0, 3 — Method: order the numbers by their position on a number line, smallest (furthest left) first. Working: both −5 and −1 lie to the left of 0, and 3 lies to the right of 0. Of the two negatives, −5 is 5 units from zero and −1 is 1 unit from zero, so −5 is further left. Answer: −5, −1, 0, 3. The distractors: 3, 0, −1, −5 is the correct order written the wrong way round, starting with the largest; −1, −5, 0, 3 comes from ordering the two negatives by the size of their digits, so that −1 is treated as the smaller; 0, −1, −5, 3 comes from believing that zero is the smallest number there is and then listing the negatives by their digits.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (a) −15 °C — Method: the lowest temperature is the reading furthest to the left on a number line, and among negative readings that is the one furthest below zero. Working: the three negative readings are 1 degree, 7 degrees and 15 degrees below zero, and 0 °C is not below zero at all. Fifteen degrees below zero is the furthest below. Answer: −15 °C. The distractors: −1 °C comes from ordering the negatives by the size of their digits, so that the smallest digit is taken as the lowest temperature; −7 °C comes from comparing 15 and 7 by their leading digits, deciding that 1 is less than 7 and so that −7 lies below −15; 0 °C comes from treating zero as the smallest number there is.
- (c) 6/8 — Method: two fractions can only be compared directly when they share a denominator, so rewrite 3/4 in eighths and then compare the numerators. Working: 5/8 is already in eighths, and 3/4 = (3 × 2)/(4 × 2) = 6/8. Comparing the numerators, 6 > 5, so Oliver eats the larger share. Answer: 6/8. The distractors: 5/8 comes from skipping the conversion altogether and assuming that a bar cut into eighths must give the bigger share because it has more pieces; once both shares are written over the same denominator, 5 eighths is one eighth less than 6 eighths. 1/8 comes from working out how much more Oliver eats, 6/8 − 5/8, instead of writing down the greater of the two shares. 7/8 comes from adding 4 to the numerator and 4 to the denominator of 3/4 instead of multiplying both by 2.
- (c) 3 or −5 — Method: a point a fixed distance from another can lie on either side of it, so move the given distance in each direction from the starting point. Working: moving 4 units to the right gives −1 + 4 = 3, and moving 4 units to the left gives −1 − 4 = −5. Answer: 3 or −5. The distractors: 5 or −3 comes from starting at 1 instead of −1, giving 1 + 4 and 1 − 4; 3 only comes from moving to the right and forgetting that the point could lie to the left as well; 4 or −4 comes from measuring the distance from zero instead of from point A, which just repeats the given distance.
- (d) −6 — Method: check each option to see if it falls strictly between −8 and −5, remembering that numbers become smaller as they get more negative. Working: −8 < −6 < −5, so −6 lies between them. Answer: −6. −9 comes from a value that is more negative than −8, so it lies outside the range, below −8. −4 comes from a value that is less negative than −5, so it lies outside the range, above −5. 6 comes from ignoring the negative signs and picking a positive number between 5 and 8.
- (a) = — Method: convert the fraction to a decimal so both numbers are in the same form. Working: 3/10 means 3 divided by 10, which is 0.3. Answer: 3/10 = 0.3, so the symbol is =. < comes from treating the fraction as smaller than the decimal without converting it first. > comes from the same mistake the other way round. ≠ comes from assuming a fraction and a decimal can never be equal.
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (c) > — Method: write both fractions with a common denominator so they can be compared directly. Working: −2/3 = −4/6. Comparing −4/6 and −5/6, −4 is greater than −5, so −4/6 is greater than −5/6. Answer: −2/3 > −5/6, so the symbol is >. < comes from treating the fraction with the larger numerator and denominator, 5/6, as the greater number, ignoring that both fractions are negative. = comes from assuming the fractions must be equal because they look similar in size. ≤ combines < (false) with = (false).
- (c) < — Compare the two decimals by their value, not by how many digits they have: 0.45 is worth less than half, while 0.5 is exactly half, so 0.45 is smaller. The correct symbol is <, since 0.45 is less than 0.5. Choosing > treats 0.45 as bigger because it has more digits after the decimal point than 0.5 — extra decimal digits do not make a number bigger. Choosing = comes from rounding 0.45 to 1 decimal place, 0.5, and then treating the rounded value as if it were the original number. Choosing ≥ would mean 0.45 is greater than or equal to 0.5, which is false in both parts, since 0.45 is neither equal to nor bigger than 0.5. So 0.45 < 0.5.
- (d) the first mark after 0 — Method: when a unit length is split into equal parts, each gap is one part of the whole, so 1/4 is one gap along from 0. Working: four equal parts means each gap measures 1/4, so the marks after 0 stand for 1/4, 2/4, 3/4 and 4/4. One gap along from 0 is therefore the mark for 1/4. Answer: the first mark after 0. The distractors: the second mark after 0 comes from counting 0 itself as the first mark; the third mark after 0 comes from counting back from the 1 end instead of forward from 0; the fourth mark after 0 comes from reading the 4 in the denominator as the number of the mark rather than the number of parts.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (c) < — Method: compare the two negative numbers by their position on a number line, not by the size of the digit. Working: −9 is nine places to the left of zero and −4 is four places to the left of zero, so −9 is further from zero in the negative direction, which makes it the smaller number. Answer: −9 < −4, so the symbol is <. > comes from comparing 9 and 4 as if both numbers were positive, ignoring the negative signs. = comes from treating both numbers as equal simply because they are both negative. ≥ combines > (false) with = (also false).
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
Build your own mix at the worksheet builder.