Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A length, L cm, has the error interval 24.5 ≤ L < 25.5. Write down the degree of accuracy to which the length was measured.
- 2.Round 6.283 to 1 significant figure.
- 3.A number, y, is equal to 8.2 when rounded to 1 decimal place. Write down the error interval for y.
- 4.Round 4,685 to the nearest 100.
- 5.Round 0.0759 to 2 decimal places.
- 6.Which of these numbers rounds to 0.048 when rounded to 2 significant figures?
- 7.The thickness of a sheet of card is 0.02384 cm. Write this thickness correct to 2 significant figures.
- 8.A digital timer truncates every time to 1 decimal place. It shows a swimmer's time for one length as 12.3 seconds. Using t for the swimmer's actual time in seconds, write down the error interval for t.
- 9.The length of a pencil is 8.4 cm, correct to 1 decimal place. Using L for the length of the pencil in centimetres, write down the error interval for L.
- 10.The length of a nail is 12 cm, correct to the nearest centimetre. Using L for the length of the nail in centimetres, write down the error interval for L.
- 11.A quantity surveyor calculates a length as 24.6851 m. Round this length to 2 decimal places.
- 12.Four friends share a restaurant bill of £53.90 equally. A calculator gives each share as 13.475. Work out how much each friend should pay.
- 13.Round 24,681 to the nearest 1,000.
- 14.A supermarket sells apples at £1.85 per kg. Anna buys 3.6 kg of apples. Estimate the cost by rounding each number to 1 significant figure before multiplying. Work out Anna's estimate.
- 15.A charity trek covers 830 miles over roughly 19 days. By rounding each number to 1 significant figure, work out an estimate for the number of miles walked per day.
Answer key
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 11.5 ≤ L < 12.5 — Rounding to the nearest centimetre means L can be up to half a centimetre below or above 12 before it would round to a different whole number. Half of 1 cm is 0.5 cm, so the lower bound is 12 − 0.5 = 11.5 and the upper bound is 12 + 0.5 = 12.5. A value exactly at the upper bound, 12.5, would round up to 13, not 12, so 12.5 itself is excluded, giving 11.5 ≤ L < 12.5. Writing 11.5 ≤ L ≤ 12.5 wrongly includes 12.5 on both ends. Writing 11 ≤ L < 13 uses a whole centimetre either side instead of half a centimetre. Writing 11.5 < L < 12.5 wrongly excludes the lower bound, which is a value that does round to 12.
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (b) £8 — Rounding to 1 significant figure: £1.85 rounds to £2, and 3.6 kg rounds to 4 kg. The estimate is £2 × 4 = £8. A candidate who used the unrounded values instead of estimating worked out 1.85 × 3.6 = £6.66. A candidate who rounded only the mass and used the exact price worked out 1.85 × 4 = £7.40. A candidate who rounded the price to the nearest 10p instead of 1 significant figure worked out 1.9 × 4 = £7.60.
- (d) 40 miles — Method: round each number to 1 significant figure first, then divide to estimate the daily distance. Working: 830 rounds to 800, and 19 rounds to 20, and 800 ÷ 20 = 40, so the estimate is 40 miles per day. 41.5 miles comes from rounding only the number of days and working out 830 ÷ 20 = 41.5, without rounding the distance too. 830 miles is the total distance for the whole trek, given as the answer without dividing by the number of days at all. 4 miles comes from working out 80 ÷ 20 = 4, misplacing a digit in the rounded distance. Answer: 40 miles.
Build your own mix at the worksheet builder.