Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A length, L cm, has the error interval 24.5 ≤ L < 25.5. Write down the degree of accuracy to which the length was measured.
- 2.A quantity surveyor calculates a length as 24.6851 m. Round this length to 2 decimal places.
- 3.Round 24,681 to the nearest 1,000.
- 4.A crowd of 8,400 people is recorded correct to the nearest 100. Work out the smallest possible number of people in the crowd.
- 5.The length of a pencil is 8.4 cm, correct to 1 decimal place. Using L for the length of the pencil in centimetres, write down the error interval for L.
- 6.Round 4,685 to the nearest 100.
- 7.A number, x, is truncated (not rounded) to 1 decimal place and the result is 6.2. Write down the error interval for x.
- 8.A tin of paint has a mass of 5.672 kg. Round this mass to 1 decimal place.
- 9.Round 0.0759 to 2 decimal places.
- 10.To estimate the cost of buying 38.7 m of rope at £21.40 per metre, both numbers are first rounded to 1 significant figure. Work out the estimate.
- 11.A recipe needs 0.485 kg of flour per cake. A bakery estimates its flour order by rounding this amount to 1 significant figure, then multiplying by the 60 cakes it plans to bake. Work out the bakery's estimate for the total flour needed, in kg.
- 12.A supermarket sells apples at £1.85 per kg. Anna buys 3.6 kg of apples. Estimate the cost by rounding each number to 1 significant figure before multiplying. Work out Anna's estimate.
- 13.Round 0.006482 to 2 significant figures.
- 14.Which of these numbers rounds to 0.048 when rounded to 2 significant figures?
- 15.Round 6.283 to 1 significant figure.
Answer key
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (c) 5.7 kg — Method: to round to 1 decimal place, keep one digit after the decimal point and let the digit in the second decimal place decide whether that digit stays as it is or goes up. Working: 5.672 has 6 in the first decimal place and 7 in the second decimal place; 7 is 5 or more, so the 6 goes up to 7 and the digits beyond the first decimal place are dropped. Answer: 5.7 kg. The distractors: 5.6 kg comes from chopping the digits after the first decimal place off instead of rounding them, which is truncation rather than rounding; 6.0 kg comes from rounding to the nearest whole kilogram instead of to 1 decimal place; 5.0 kg comes from chopping everything after the decimal point off, so the mass is both truncated and given to the wrong degree of accuracy.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (d) £800 — Rounding 38.7 to 1 significant figure gives 40, and rounding 21.40 to 1 significant figure gives 20. Multiplying the rounded values gives an estimate of 40 × 20 = £800. Rounding 21.40 to the nearest whole number instead of to 1 significant figure gives 21, and 40 × 21 = £840, one place value too fine for the price. Adding the rounded values instead of multiplying them gives 40 + 20 = £60. Rounding both numbers to 2 significant figures instead of 1, giving 39 and 21, produces 39 × 21 = £819.
- (d) 30 kg — Round 0.485 kg to 1 significant figure: 0.5 kg. Multiply by the 60 cakes: 0.5 × 60 = 30 kg. A candidate who rounded to 2 significant figures instead of 1 used 0.49 kg, giving 0.49 × 60 = 29.4 kg. A candidate who used the unrounded amount instead of the estimate worked out 0.485 × 60 = 29.1 kg. A candidate who rounded 0.485 down to 0.4 kg instead of up to 0.5 kg worked out 0.4 × 60 = 24 kg.
- (b) £8 — Rounding to 1 significant figure: £1.85 rounds to £2, and 3.6 kg rounds to 4 kg. The estimate is £2 × 4 = £8. A candidate who used the unrounded values instead of estimating worked out 1.85 × 3.6 = £6.66. A candidate who rounded only the mass and used the exact price worked out 1.85 × 4 = £7.40. A candidate who rounded the price to the nearest 10p instead of 1 significant figure worked out 1.9 × 4 = £7.60.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
Build your own mix at the worksheet builder.