Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (b) £8 — Rounding to 1 significant figure: £1.85 rounds to £2, and 3.6 kg rounds to 4 kg. The estimate is £2 × 4 = £8. A candidate who used the unrounded values instead of estimating worked out 1.85 × 3.6 = £6.66. A candidate who rounded only the mass and used the exact price worked out 1.85 × 4 = £7.40. A candidate who rounded the price to the nearest 10p instead of 1 significant figure worked out 1.9 × 4 = £7.60.
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (a) 11.5 ≤ L < 12.5 — Rounding to the nearest centimetre means L can be up to half a centimetre below or above 12 before it would round to a different whole number. Half of 1 cm is 0.5 cm, so the lower bound is 12 − 0.5 = 11.5 and the upper bound is 12 + 0.5 = 12.5. A value exactly at the upper bound, 12.5, would round up to 13, not 12, so 12.5 itself is excluded, giving 11.5 ≤ L < 12.5. Writing 11.5 ≤ L ≤ 12.5 wrongly includes 12.5 on both ends. Writing 11 ≤ L < 13 uses a whole centimetre either side instead of half a centimetre. Writing 11.5 < L < 12.5 wrongly excludes the lower bound, which is a value that does round to 12.
- (d) £800 — Rounding 38.7 to 1 significant figure gives 40, and rounding 21.40 to 1 significant figure gives 20. Multiplying the rounded values gives an estimate of 40 × 20 = £800. Rounding 21.40 to the nearest whole number instead of to 1 significant figure gives 21, and 40 × 21 = £840, one place value too fine for the price. Adding the rounded values instead of multiplying them gives 40 + 20 = £60. Rounding both numbers to 2 significant figures instead of 1, giving 39 and 21, produces 39 × 21 = £819.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (b) £13.48 — Method: an amount of money is written to the nearest penny, which is 2 decimal places, so the calculator display has to be rounded to 2 decimal places. Working: 53.90 ÷ 4 = 13.475, and the digit in the third decimal place is 5, so the penny digit goes up from 7 to 8. Answer: £13.48. The distractors: £13.47 comes from chopping the third decimal place off instead of rounding with it; £13.50 comes from rounding to the nearest 10p rather than to the nearest penny; £13.40 comes from cutting the display short at 1 decimal place, which is both the wrong degree of accuracy and a truncation rather than a rounding.
- (a) 330 ml — Correct to the nearest 20 ml means the true volume could be up to 10 ml (half of 20) either side of 340 ml. The smallest possible volume is 340 − 10 = 330 ml. A candidate who subtracted the full 20 ml instead of half of it worked out 340 − 20 = 320 ml. A candidate who added instead of subtracted, finding the largest possible volume instead of the smallest, worked out 340 + 10 = 350 ml. A candidate who halved the interval again by mistake, using 5 ml instead of 10 ml, worked out 340 − 5 = 335 ml.
Build your own mix at the worksheet builder.