Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (d) 40 miles — Method: round each number to 1 significant figure first, then divide to estimate the daily distance. Working: 830 rounds to 800, and 19 rounds to 20, and 800 ÷ 20 = 40, so the estimate is 40 miles per day. 41.5 miles comes from rounding only the number of days and working out 830 ÷ 20 = 41.5, without rounding the distance too. 830 miles is the total distance for the whole trek, given as the answer without dividing by the number of days at all. 4 miles comes from working out 80 ÷ 20 = 4, misplacing a digit in the rounded distance. Answer: 40 miles.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (c) 590 — To round to the nearest 10, decide which multiple of 10 the number is nearer to. 592.5 lies between 590 and 600. It is 592.5 − 590 = 2.5 above 590, but 600 − 592.5 = 7.5 below 600, so it is much nearer to 590. Equivalently, the units digit is 2, and 2 is less than 5, so round down: 592.5 rounds to 590. A candidate who wrote 600 rounded up because of the 5 in the tenths place, but that digit decides rounding to the nearest whole number, not to the nearest 10 — the units digit is what matters here. A candidate who wrote 595 rounded to the nearest 5 instead of the nearest 10. A candidate who wrote 500 cut the number down to its hundreds digit instead of rounding to the nearest 10.
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (a) 11.5 ≤ L < 12.5 — Rounding to the nearest centimetre means L can be up to half a centimetre below or above 12 before it would round to a different whole number. Half of 1 cm is 0.5 cm, so the lower bound is 12 − 0.5 = 11.5 and the upper bound is 12 + 0.5 = 12.5. A value exactly at the upper bound, 12.5, would round up to 13, not 12, so 12.5 itself is excluded, giving 11.5 ≤ L < 12.5. Writing 11.5 ≤ L ≤ 12.5 wrongly includes 12.5 on both ends. Writing 11 ≤ L < 13 uses a whole centimetre either side instead of half a centimetre. Writing 11.5 < L < 12.5 wrongly excludes the lower bound, which is a value that does round to 12.
- (a) 330 ml — Correct to the nearest 20 ml means the true volume could be up to 10 ml (half of 20) either side of 340 ml. The smallest possible volume is 340 − 10 = 330 ml. A candidate who subtracted the full 20 ml instead of half of it worked out 340 − 20 = 320 ml. A candidate who added instead of subtracted, finding the largest possible volume instead of the smallest, worked out 340 + 10 = 350 ml. A candidate who halved the interval again by mistake, using 5 ml instead of 10 ml, worked out 340 − 5 = 335 ml.
- (d) 30 kg — Round 0.485 kg to 1 significant figure: 0.5 kg. Multiply by the 60 cakes: 0.5 × 60 = 30 kg. A candidate who rounded to 2 significant figures instead of 1 used 0.49 kg, giving 0.49 × 60 = 29.4 kg. A candidate who used the unrounded amount instead of the estimate worked out 0.485 × 60 = 29.1 kg. A candidate who rounded 0.485 down to 0.4 kg instead of up to 0.5 kg worked out 0.4 × 60 = 24 kg.
- (d) £800 — Rounding 38.7 to 1 significant figure gives 40, and rounding 21.40 to 1 significant figure gives 20. Multiplying the rounded values gives an estimate of 40 × 20 = £800. Rounding 21.40 to the nearest whole number instead of to 1 significant figure gives 21, and 40 × 21 = £840, one place value too fine for the price. Adding the rounded values instead of multiplying them gives 40 + 20 = £60. Rounding both numbers to 2 significant figures instead of 1, giving 39 and 21, produces 39 × 21 = £819.
- (b) 245 ≤ m < 255 — Method: a mass given to the nearest 10 g lies within half of 10 g, that is 5 g, of the figure written down. The lower limit is included because it rounds up to that figure, and the upper limit is excluded because it rounds up to the next multiple of 10. Working: 250 − 5 = 245 and 250 + 5 = 255, and a mass of 245 g rounds to 250 g while a mass of 255 g rounds to 260 g. Answer: 245 ≤ m < 255. The distractors: 240 ≤ m < 260 goes a whole 10 g either side instead of half of it; 245 < m ≤ 255 has the two limits the wrong way round; 240 ≤ m < 250 treats the stated 250 g as the largest mass possible, as though rounding were always upwards.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
Build your own mix at the worksheet builder.