Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 24.69 — To round to 2 decimal places, look only at the third decimal digit to decide whether the second decimal digit rounds up. In 24.6851 the third decimal digit is 5, and since 5 is 5 or more, the second decimal digit rounds up from 8 to 9, giving 24.69. Rounding to 1 decimal place instead of 2 gives 24.7, one place value too coarse. Keeping the third decimal digit rather than dropping it gives 24.685, which is 3 decimal places. Looking at the fourth decimal digit, 1, instead of the third one, and wrongly deciding that no rounding is needed, leaves the length unrounded at 24.68.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (d) 40 miles — Method: round each number to 1 significant figure first, then divide to estimate the daily distance. Working: 830 rounds to 800, and 19 rounds to 20, and 800 ÷ 20 = 40, so the estimate is 40 miles per day. 41.5 miles comes from rounding only the number of days and working out 830 ÷ 20 = 41.5, without rounding the distance too. 830 miles is the total distance for the whole trek, given as the answer without dividing by the number of days at all. 4 miles comes from working out 80 ÷ 20 = 4, misplacing a digit in the rounded distance. Answer: 40 miles.
- (a) 11.5 ≤ L < 12.5 — Rounding to the nearest centimetre means L can be up to half a centimetre below or above 12 before it would round to a different whole number. Half of 1 cm is 0.5 cm, so the lower bound is 12 − 0.5 = 11.5 and the upper bound is 12 + 0.5 = 12.5. A value exactly at the upper bound, 12.5, would round up to 13, not 12, so 12.5 itself is excluded, giving 11.5 ≤ L < 12.5. Writing 11.5 ≤ L ≤ 12.5 wrongly includes 12.5 on both ends. Writing 11 ≤ L < 13 uses a whole centimetre either side instead of half a centimetre. Writing 11.5 < L < 12.5 wrongly excludes the lower bound, which is a value that does round to 12.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (c) 590 — To round to the nearest 10, decide which multiple of 10 the number is nearer to. 592.5 lies between 590 and 600. It is 592.5 − 590 = 2.5 above 590, but 600 − 592.5 = 7.5 below 600, so it is much nearer to 590. Equivalently, the units digit is 2, and 2 is less than 5, so round down: 592.5 rounds to 590. A candidate who wrote 600 rounded up because of the 5 in the tenths place, but that digit decides rounding to the nearest whole number, not to the nearest 10 — the units digit is what matters here. A candidate who wrote 595 rounded to the nearest 5 instead of the nearest 10. A candidate who wrote 500 cut the number down to its hundreds digit instead of rounding to the nearest 10.
- (b) 3.65 ≤ n < 3.75 — Rounding to 1 decimal place means n can be up to half of one decimal place, 0.05, below or above 3.7 before it would round to a different value. This gives a lower bound of 3.7 − 0.05 = 3.65 and an upper bound of 3.7 + 0.05 = 3.75. A value exactly at 3.75 would round up to 3.8, not 3.7, so the upper bound is excluded while the lower bound, 3.65, does still round to 3.7. Writing 3.65 ≤ n ≤ 3.75 wrongly includes 3.75. Writing 3.6 ≤ n < 3.8 uses a whole decimal place, 0.1, either side instead of half of one, 0.05. Writing 3.65 < n < 3.75 wrongly excludes 3.65, which does round to 3.7.
- (c) 3.95 — The digit after the second decimal place is 7, which is 5 or more, so round the second decimal place up: 3.947 rounds to 3.95. A candidate who truncated instead of rounding, simply cutting off after 2 decimal places, wrote 3.94. A candidate who rounded to 1 decimal place instead of 2 wrote 3.9. A candidate who rounded up but mishandled the carry wrote 4.0.
Build your own mix at the worksheet builder.